Abstract:The effect of both the Fe : Ni ratio (5 to 1 : 1) and the relative Lewis acidity of a metal oxide support on catalytic activity, selectivity and stability was investigated in the CO2 mediated oxidative dehydrogenation of ethane (CO2-ODH). To avoid effects of varying pore sizes, shapes and volumes of the supports, chromia and zirconia overlayers were coated onto a common γ-Al2O3 carrier (CrOx@Al2O3 and ZrOx@Al2O3). Separately, oxidic FexNiy alloy precursor nanoparticles were prepared using a nonaqueous surfactant-free method and deposited by sonication onto the carrier. In comparison to previous studies in the field, this synthesis technique yields closely associated iron and nickel increasing the chances for alloy formation. During reduction, a mixture of a bcc and a fcc alloy phase was formed, with the content of bcc increasing with increasing iron content as predicted by the bulk phase diagram. Upon exposure to carbon dioxide at elevated temperatures, the bcc metallic phase is selectively oxidised to an inverse spinel structure via the dissociation of CO2. When exposed to CO2-ODH conditions, the bare ZrOx@Al2O3 support shows no activity. The presence of FeNi phases increases the conversion of ethane and CO2 marginally (<2%) but forms ethylene at high selectivity (SC2H4 > 80%). The CrOx@Al2O3 support shows some initial activity (XC2H6 < 5%) at very high ethylene selectivity (SC2H4 > 90%) but deactivates with time on stream. Comparison of the ethane and carbon dioxide conversions suggests that direct dehydrogenation rather than the oxidative pathway is taking place. When FeNi particles with the highest Fe content are added, the ethane conversion behavior hardly changes, but the CO2 conversion is increased now supporting the stoichiometric CO2-ODH reaction (SC2H4 > 95%). It is therefore evident that a tandem catalyst system between a reducible oxide carrier and the FeNi species is required. Increasing the Ni content results in an increase in activity and stability while changing the dominant reaction pathway to a combination of dry reforming, CO2-ODH and possibly the reverse Boudouard reaction, with the latter countering catalyst deactivation through carbon deposition.

Boosting Amination of 1‐octanol to 1‐octylamine Via Metal‐Metal Oxide Interactions in NixFe1/Al2O3 Catalysts

Reductive Amination of 5-Hydroxymethylfurfural to 2,5-Bis(aminomethyl)furan over Alumina-Supported Ni-based Catalytic Systems.

Amination of Aliphatic Alcohols Catalyzed by CuO–NiO/γ–Al2O3

Modulation of Charge Distribution Enabling CuNi Nano-Alloys for Efficient Ammonia Oxidation Reaction to Nitrite Production

Coexistence of Fe Nanoclusters Boosting Fe Single Atoms to Generate Singlet Oxygen for Efficient Aerobic Oxidation of Primary Amines to Imines

Combining Ni3P and Lewis Acid–Base Pair As a High-Performance Catalyst for Amination of 1-Octanol

Amination of n‐hexanol to n‐hexylamine over RuNi bimetallic catalyst

Catalytic Fe2+ Cation Pair Site for Base‐free N‐Alkylation of Aromatic Amines with Alcohols

Atomic-Level Asymmetric Tuning of the Co1-N3P1 Catalyst for Highly Efficient N-Alkylation of Amines with Alcohols.

Selective amination of furfuryl alcohol to furfurylamine over nickel catalysts promoted by alumina encapsulation

Highly-dispersed Ni 3 Fe alloy nanoparticles anchored on MgAl-LDO for efficient catalytic amination of KA-oil to cyclohexylamine

Supported FexNiy catalysts for the co-activation of CO2 and small alkanes

Promoting Amination of Furfural to Furfurylamine by Metal-Support Interactions on Pd/MoO3-x Catalysts

Importance of oxyphilic FeNi alloy in NiFeAl catalysts for selective conversion of biomass-derived 5-hydroxymethylfurfural to 2,5-dimethylfuran

Rational design of selective metal catalysts for alcohol amination with ammonia

Boosting electrocatalytic oxidation of heterocyclic alcohols with low usage aminoxyl radicals via MOF‐derived NiOOH

Preparation of NiAlOx and NiSiOx Complex Oxides with High Surface Areas for the Isomerization Reactions of 1-Hexene

Host-guest Chemistry Immobilized Nickel Nanoparticles on Zeolites As Efficient Catalysts for Amination of 1-Octanol

Synergistic effects of the bimetallic Ni-Fe systems and their application in the reductive amination of polyether polyols

FeNi 3 /NiFe-Mixed Metal Oxide Heterostructured Nanosheets for Catalytic Nitro-Amination

Engineering a Ni 1 Fe 1 –ZnO Interface to Boost Selective Hydrogenation of Methyl Stearate to Octadecanol