Abstract:The high-volume SiCp/Al (65%) composite material possesses excellent properties of both aluminum alloy and SiC. Its drilling process is widely utilized in various fields such as the national defense industry, electronic communication, aerospace, etc. Drilling with ultrasonic vibrations has shown promising results when used for high-volume drilling in SiCp/Al. Because of the strong correlation between drilling force and hole quality, it is very important to predict the drilling force to optimize the drilling parameters to improve the processing quality and efficiency. However, the prediction of drilling force for high volume fraction SiCp/Al in UVAD is still a problem. This study establishes a theoretical mechanical model that considers ultrasonic vibration and undeformed cutting thickness. Especially, the main cutting edge and the transverse edge of the drill bit are divided into several small units. The cutting force and torque of each unit are solved using oblique cutting theory and orthogonal theory, and the axial force and torque of the drill bit as a whole are calculated using the integration method. This model not only considers the influence of ultrasonic vibration on drilling force but also introduces a new reference, undeformed cutting thickness. In addition, a three-dimensional simulation model was established. Finally, the effectiveness of the theoretical drilling force model and simulation model in predicting axial force and torque during the drilling process of SiCp/Al composite materials was verified through experiments. The average error of the three-dimensional model in predicting axial force was 7.11%, and the average error of torque was 7.19%. The average error of the mechanical model in predicting axial force was 10.49%, and the average error of torque was 13.05%.

Thrust Force Model for Ultrasonic-Assisted Micro Drilling of DD6 Superalloy

Modeling of Burr Height in Ultrasonic-Assisted Drilling of DD6 Superalloy

Research on Ultrasonic-Assisted Drilling in Micro-Hole Machining of the DD6 Superalloy

Modeling of Non-Linear Cutting Forces for Dry Orbital Drilling Process Based on Undeformed Chip Geometry

Investigation of Force Modeling in Ultrasonic Vibration-Assisted Drilling SiCf/SiC Ceramic Matrix Composites

Drilling force model for forced low frequency vibration assisted drilling of Ti-6Al-4V titanium alloy

Modeling and experimental analysis of ultrasonic vibration drilling force prediction model for tiny small holes in high body fraction aluminum-based silicon carbide composites

Study on thrust force of ultrasonic-assisted vibration micro-hole drilling of titanium alloy

Analytical Model of Cutting Force in Axial Ultrasonic Vibration-Assisted Milling In-Situ TiB2/7050Al PRMMCs

Three-dimensional dynamic cutting forces prediction model during micro-milling nickel-based superalloy

Study on the predicted model and experiment of drilling forces in drilling Ti6Al4V

Mechanical Model of Thrust Force and Torque in Longitudinal-Torsional Coupled Ultrasonic-Assisted Drilling of CFRP

A Cutting Force Model Based on Kinematic Analysis in Longitudinal and Torsional Ultrasonic Vibration Drilling

Mechanical Drilling Force Model for Longitudinal Ultrasonic Vibration-assisted Drilling of Unidirectional CFRP

Modeling and optimization of thrust force, torque, and surface roughness in ultrasonic-assisted drilling using surface response methodology

Modeling Evolution of Cutting Force in Ultrasonically Assisted Drilling of Carbon Fiber Reinforced Plastics

Comparison of Thrust Force in Ultrasonic Assisted Drilling and Conventional Drilling of Aluminum Alloy

A Mathematical Model for Predicting Cutting Force in Rotary Ultrasonic Drilling

Modeling of cutting forces in 1-D and 2-D ultrasonic vibration-assisted milling of Ti-6Al-4V

Cutting Force Prediction Model Considering Tool-Chip Contact Interface Friction Behavior in ULTVAM of Ti-6Al-4V

Study on the Simulation and Experiment of Ultrasonic-assisted Vibration Drilling of Ti6Al4V