Abstract:The high-volume SiCp/Al (65%) composite material possesses excellent properties of both aluminum alloy and SiC. Its drilling process is widely utilized in various fields such as the national defense industry, electronic communication, aerospace, etc. Drilling with ultrasonic vibrations has shown promising results when used for high-volume drilling in SiCp/Al. Because of the strong correlation between drilling force and hole quality, it is very important to predict the drilling force to optimize the drilling parameters to improve the processing quality and efficiency. However, the prediction of drilling force for high volume fraction SiCp/Al in UVAD is still a problem. This study establishes a theoretical mechanical model that considers ultrasonic vibration and undeformed cutting thickness. Especially, the main cutting edge and the transverse edge of the drill bit are divided into several small units. The cutting force and torque of each unit are solved using oblique cutting theory and orthogonal theory, and the axial force and torque of the drill bit as a whole are calculated using the integration method. This model not only considers the influence of ultrasonic vibration on drilling force but also introduces a new reference, undeformed cutting thickness. In addition, a three-dimensional simulation model was established. Finally, the effectiveness of the theoretical drilling force model and simulation model in predicting axial force and torque during the drilling process of SiCp/Al composite materials was verified through experiments. The average error of the three-dimensional model in predicting axial force was 7.11%, and the average error of torque was 7.19%. The average error of the mechanical model in predicting axial force was 10.49%, and the average error of torque was 13.05%.

Modeling of Burr Height in Ultrasonic-Assisted Drilling of DD6 Superalloy

Clamping force prediction for automatic drilling of stacked thin-walled workpieces based on finite element method

Exit Burr Height Mechanistic Modeling and Experimental Validation for Low-Frequency Vibration-Assisted Drilling of Aluminum 7075-T6 Alloy

Modeling of Non-Linear Cutting Forces for Dry Orbital Drilling Process Based on Undeformed Chip Geometry

Modeling and experimental analysis of ultrasonic vibration drilling force prediction model for tiny small holes in high body fraction aluminum-based silicon carbide composites

Predictive Model for the Interlayer Burr Height During Drilling of Stacked Aluminum Plates

Modeling and Drilling Parameters Optimization on Burr Height Using Harmony Search Algorithm in Low-Frequency Vibration-Assisted Drilling

Development of an enhanced burr accumulation model during orthogonal cutting of nickel-based super alloy

Decay-based Ranking for Social Application Content

Model for the prediction of 3D surface topography and surface roughness in micro-milling Inconel 718

Mechanical Drilling Force Model for Longitudinal Ultrasonic Vibration-assisted Drilling of Unidirectional CFRP

Modeling and optimization of thrust force, torque, and surface roughness in ultrasonic-assisted drilling using surface response methodology

Study on ultrasonic-assisted drilling of Ti6Al4V using 3-flute drill in the finite element simulation

Drilling force model for forced low frequency vibration assisted drilling of Ti-6Al-4V titanium alloy

Burr formation mechanism and experimental research in longitudinal-torsional ultrasonic-assisted milling Ti-6Al-4 V

Evaluation of different tool geometries in the finite element simulation of ultrasonic-assisted drilling of Ti6A14V

Study on the Simulation and Experiment of Ultrasonic-assisted Vibration Drilling of Ti6Al4V

Modeling Evolution of Cutting Force in Ultrasonically Assisted Drilling of Carbon Fiber Reinforced Plastics

Suppressing the burr of high aspect ratio structure by optimizing the cutting parameters in the micro-milling process

Investigation of force modeling in ultrasonic vibration-assisted drilling SiC f /SiC ceramic matrix composites