EMC3-EIRENE simulations of neon impurity seeding effects on heat flux distribution on CFETR

S. Y. Dai,D. F. Kong,V. S. Chan,L. Wang,Y. Feng,D. Z. Wang
DOI: https://doi.org/10.1088/1741-4326/ac47b5
IF: 3.3
2022-01-01
Nuclear Fusion
Abstract:The numerical modelling of the heat flux distribution with neon impurity seeding on China fusion engineering test reactor has been performed by the three-dimensional (3D) edge transport code EMC3-EIRENE. The maximum heat flux on divertor targets is about 18 MW m(-2) without impurity seeding under the input power of 200 MW entering into the scrape-off layer. In order to mitigate the heat loads below 10 MW m(-2), neon impurity seeded at different poloidal positions has been investigated to understand the properties of impurity concentration and heat load distributions for a single toroidal injection location. The majority of the studied neon injections gives rise to a toroidally asymmetric profile of heat load deposition on the in- or out-board divertor targets. The heat loads cannot be reduced below 10 MW m(-2) along the whole torus for a single toroidal injection location. In order to achieve the heat load mitigation (<10 MW m(-2)) along the entire torus, modelling of sole and simultaneous multi-toroidal neon injections near the in- and out-board strike points has been stimulated, which indicates that the simultaneous multi-toroidal neon injections show a better heat flux mitigation on both in- and out-board divertor targets. The maximum heat flux can be reduced below 7 MW m(-2) on divertor targets for the studied scenarios of the simultaneous multi-toroidal neon injections.
What problem does this paper attempt to address?