Abstract:In this work, a three-dimensional finite element model of a newly structured high-speed continuous casting mold was established to study the heat transfer and solidification process of the billet shell. A complete billet shell, from the meniscus to the secondary cooling zone, was obtained through flame cutting. Using both simulations and test verification, detailed analyses were conducted on the temperature field distribution, thickness variation law, and cooling rate law of the billet shell within the mold, revealing its solidification behavior. Additionally, the effects of casting speed, molten steel superheat, and mold taper on the solidification behavior of the billet shell were discussed. Results showed that the simulation data were basically consistent with the test verification results. Within 200 mm from the meniscus, the heat dissipation accounted for three-quarters of the mold's total heat dissipation. The cooling rate at the corners of the billet shell was slightly higher than that at the sides. Between 200 mm and 400 mm from the meniscus, air gaps caused the temperature at the corners of the billet shell to rise. Afterwards, the whole billet shell eventually reached a similar the heat dissipation rates. The thickness of the billet shell increased exponentially within 110 mm from the curved meniscus, and from 110 mm to the exit of the mold, the thickness increased linearly but slowly. The effect of molten steel superheat within a range of 10 °C on billet shell solidification was relatively minor. Increasing the casting speed reduced the billet shell thickness and raised the billet shell surface temperature. However, increasing the taper of the mold had the opposite effect. Both adjustments shifted the gap formation position backward.

Finite element numerical simulation on solidification and stress of continuous casting billet in mold

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Thermomechanical Behavior of Round Billet in Continuous Casting Mold

Calculation of Continuous Casting Billet Solidification Based on Element-Free Galerkin Method

Study on solidification and heat transfer of billet shell in a new-structure high-speed continuous casting mold

Numerical simulation on solidification and thermal stress of continuous casting billet in mold based on meshless methods

FINITE ELEMENT ANALYSIS OF THERMO-MECHANICAL COUPLED SOLIDIFICATION PROCESS OF CONTINUOUS CASTING SLAB IN MOLD

Coupling Numerical Simulation of Flow Field, Temperature Field and Stress Field in a Wide-Thick Slab Continuous Casting Mold

Thermomechanical Analysis of Continuous Casting Round Billet Based on the Element-Free Galerkin Method

Numerical Simulation of the Fluid Flow, Heat Transfer, and Solidification in Ultrahigh Speed Continuous Casting Billet Mold

Numerical Analysis of Solidified Shells in Moulds for Continuous Casting of Thin Slabs

Continuous Casting Novel Mould for Round Steel Billet Optimised by Solidification Shrinkage Simulation

Finite Element Analysis of Shell Growth in a Continuous Casting Mold

3D Stress Model with Friction in and of Mould for Round Billet Continuous Casting

A coupled model on fluid flow, heat transfer and solidification in continuous casting mold

Numerical Simulation of the Thermo-Mechanical Process for Beam Blank Continuous Casting

Element-Free Galerkin Meshless Method on Solidification Behavior Inside Continuous Casting Mold

Simulation of Temperature Field and Prediction of Shell Thickness in a Continuous Casting Mould of Round Billets

INTEGRATED FINITE ELEMENT MODEL FOR TRANSIENT FLUID FLOW AND THERMAL STRESSES DURING CONTINUOUS CASTING

Finite element numerical simulation on Thermo Mechanical couple in bloom mold

Numerical Modelling of Chamfer Billet of High Carbon Steel During Continuous Casting