Abstract:A 2-kW-class chemical oxygen-iodine laser (COIL) using nitrogen buffer gas has been developed and tested since industrial applications of COIL devices will require the use of nitrogen as the buffer gas. The laser, with a gain length of 11.7 cm, is energized by a square pipe-array jet-type singlet oxygen generator (SPJSOG) and employs a nozzle bank with a designed Mach number of 2.5. The SPJSOG has advantages over the traditional plate-type JSOG in that it has less requirements on basic hydrogen peroxide (BHP) pump, and more important, it has much better operational stability. The SPJSOG without a cold trap and a gas-liquid separator could provide reliable operations for a total gas flow rate up to 450 mmol/s and with a low liquid driving pressure of around 0.7 atm or even lower. The nozzle bank was specially designed for a COIL using nitrogen as the buffer gas. The cavity was designed for a Mach number of 2.5, in order to provide a gas speed and static temperature in the cavity similar to that for a traditional COIL with helium buffer gas and a Mach 2 nozzle. An output power of 2.6 kW was obtained for a chlorine flow rate of 140 mmol/s, corresponding to a chemical efficiency of 20.4%. When the chlorine flow rate was reduced to 115 mmol/s, a higher chemical efficiency of 22.7% was attained. Measurements showed that the SPJSOG during normal operation could provide a singlet oxygen yield Y greater than or equal to 55%, a chlorine utilization U greater than or equal to 85%, and a relative water vapor concentration w = [H2O]/([O-2] + [Cl-2]) less than or equal to 0.1.

Phase retarder in chemical oxygen-iodine laser at 45-deg. incidence

Phase retarder in chemical oxygen-iodine laser at 45° incidence

Investigation on Preparation and Performance of Phase Retarder in Chemical Oxygen-Iodine Laser

Preparation and Performance of Phase Retarder at the Wavelength of 1315Nm

Design and Fabrication of Infrared Hybrid Refractive/diffractive Optical System for 3-5Μm Band

Investigation on Properties of Reflection Phase Retarder

Dielectric multilayer beam splitter with differential phase shift on transmission and reflection for division-of-amplitude photopolarimeter.

Design of 90° Reflection-Induced Phase Retarder

Phase degradation of liquid crystal variable retarders and preconfiguring method for high-power continuous-wave laser

High-performance Optical Retarders Based on All-Dielectric Immersion Nanogratings

Deep-subwavelength Phase Retarders at Mid-Infrared Frequencies with van der Waals Flakes

A Digital Optical Phase-Locked Loop For Diode Lasers Based On Field Programmable Gate Array

Measurement Method for Optical Retardation Based on the Phase Difference Effect of Laser Feedback Fringes.

Generation of Phase Difference Between Self-Mixing Signals in A-Cut Nd:Yvo4 Laser with A Waveplate in the External Cavity

A 2-Kw COIL with a Square Pipe-Array JSOG and Nitrogen Buffer Gas

Liquid crystal wave plate operating close to 18 THz

Phase retardation measurement by analyzing flipping points of polarization states in laser with an anisotropy feedback cavity

Optimal Design of an Achromatic Angle-Insensitive Phase Retarder Used in Mwir Imaging Polarimetry

Design And Manufacture Of Continuous Phase Diffractive Optical Element For Beam Transform

Measurement of phase retardation of optical multilayer films based on laser feedback system

A Broadband Silicon Quarter-Wave Retarder for Far-Infrared Spectroscopic Circular Dichroism