Abstract:<p>Wavelength-switchable fiber laser systems have many potential applications. Herein, the use of an erbium-doped fiber laser based on parallel fiber Bragg gratings (FBGs) (ASE: amplified spontaneous emission; BRM: broadband reflection mirror; CCD: charged-coupled device; EDFL: erbium-doped fiber laser; FBG: fiber Bragg gratings; IR: infrared; MZI: Mach–Zehnder interferometer; OSA: optical spectrum analyzer; OC: output coupler; PC: polarization controller; SNR: signal-to-noise ratios; 3D: three-dimensional; wavelength division multiplexing (WDM)) is proposed to achieve C + L band triple-wavelength-switchable laser output at approximately 1.5 μm. In the proposed system configuration, three parallel FBGs with different resonant wavelengths were fabricated using an 800 nm femtosecond pulsed laser. The proposed fiber laser incorporates first-order FBGs with the periods of 538, 542, and 547 nm. The femtosecond laser was propagated through polyimide coating and cladding and was focused onto the fiber core by a 63× oil lens, while FBGs were inscribed with the use of a point-by-point method to generate resonant wavelengths at 1555.3, 1569.2, and 1583.1 nm. When the FBGs were used as wavelength selectors, a lasing threshold of 85 mW was obtained, and switchable lasing with stable single- and dual-wavelength outputs was achieved based on the adjustment of a polarization controller. Concerning the switchable single-wavelength lasing, the signal-to-noise ratio was greater than 37.23 dB, and the 3 dB linewidth was less than 0.09 nm. The respective power fluctuation measurements were less than 0.22 and 0.68 dB for the single- and dual-wavelength lasers at 26 °C over a scan time of 30 min.</p>

Multiwavelength Erbium-Doped Fiber Lasers with Tilted Bragg Gratings in Single Mode Fibers

Multifrequency Erbium-Doped Fiber Laser Operating at Room Temperature

Stable Multi-Wavelength Erbium-Doped Fiber Laser Based on Dispersion-Shifted Fiber and Sagnac Loop Filter

Stable Multi-Wavelength Erbium-Doped Fiber Laser by Using Dispersion-Shifted Fiber

Individually Switchable and Widely Tunable Multiwavelength Erbium-Doped Fiber Laser Based on Cascaded Mismatching Long-Period Fiber Gratings

Single-polarization, switchable dual-wavelength erbium-doped fiber laser with two polarization-maintaining fiber Bragg gratings

Multiwavelength Erbium-Doped Fiber Laser Based on a Nonlinear Amplifying Loop Mirror Assisted by Un-Pumped EDF

Wavelength-switchable erbium-doped fiber laser incorporating fiber Bragg grating array fabricated by infrared femtosecond laser inscription

Switchable Multiwavelength Erbium-Doped Fiber Laser with Cascaded Fiber Bragg Gratings and Dual-Section Lyot–Sagnac Filter

Tunable Multiwavelength Erbium-Doped Fiber Laser Based on Nonlinear Optical Loop Mirror and Birefringence Fiber Filter

Multiwavelength Erbium-Doped Fiber Laser Based on Nonlinear Polarization Rotation Assisted by Four-Wave-mixing

Multiwavelength Erbium-Doped Fiber Ring Laser Using a LiNbO 3 Multifunction Chip for Fiber Gyroscope

Tunable erbium-doped-fiber laser based on the Double-Superimposed Fiber Bragg Gratings

Single-Longitudinal-Mode Erbium-Doped Fiber Ring Laser Based on High Finesse Fiber Bragg Grating Fabry–PÉrot Etalon

Switchable multiwavelength ytterbium-doped double-clad fiber laser based on a multimode fiber grating

Multi-wavelength Erbium-doped fiber laser based on four-wave-mixing effect in single mode fiber and high nonlinear fiber.

Multi-wavelength Erbium-doped Fiber Laser with Single Mode Fiber and High Nonlinear Fiber

Multiwavelength Erbium-Doped Fiber Laser Based on an All-Fiber Polarization Interference Filter

Multiwavelength Linear-Cavity Fiber Laser Source Using a Sagnac Interferemetric Filter and a Strain-Induced Chirped Fiber Grating

Demodulation of a Fiber Bragg Grating Sensor System Based on a Linear Cavity Multi-Wavelength Fiber Laser