Abstract:Recently, a new type of carbonate reservoir, the fault-karst carbonate reservoir has attracted lots of attention, which usually develops large-scale karst caves, vugs, and high-angle fractures along the strike-slip fault zones. Despite containing plenty of hydrocarbon resources, the complex geological structure and the strong heterogeneity make it difficult to develop this kind of reservoir effectively and economically. To perform water-drive experiments and investigate the production performance under different well patterns and injection-production modes, two 2D visualized physical models were designed and fabricated based on the typical geological structures of the fault-karst carbonate reservoir in the vertical and horizontal directions, respectively. According to the experimental results, the average oil recovery can reach 62.96% for the vertical model and 58.18% for the horizontal model. In fact, gravity effect due to density differences can greatly improve the displacement efficiency of oil by water in the vertical direction; hence, the horizontal heterogeneity would have a relatively greater impact on waterflooding development. When water is injected into the reservoir from the middle section, a large amount of un-swept oil will remain at the bottom fractures. Thus, the Bottom Injection & Top Production (BI & TP) mode should be adopted in all well patterns to increase recovery. If non-inverted well patterns are employed, dominant water channeling would form quickly in the horizontal direction, and the swept area will be hugely limited. Therefore, the Center Injection & Edge Production mode (inverted well patterns) is recommended for water-drive applications. It is also found that the water breakthrough time negatively correlates with the effective flooding time for the vertical model and the total oil recovery is more impacted by water breakthrough for both models. Additionally, the oil-water exchange ratio is introduced to evaluate the utilization efficiency of injected water. Calculation results have shown that the BI & TP mode is optimal in terms of either total recovery or oil-water exchange ratio in the vertical direction, but the well pattern layout in the horizontal direction could impact the oil recovery and oil-water exchange ratio, which, in turn, affect the project economics. This study provides novel insights for optimizing well patterns and waterflooding measures in actual fault-karst carbonate reservoirs.

Study on the injection capacity of water injection well with the consideration of start-up pressure gradient

The injection capacity evaluation of high-pressure water injection in low permeability reservoir: numerical and case study

Improved capacitance model considering bottom-hole flowing pressure and interference between oil wells

Optimization of Water Injection Strategy Before Re-Stimulation Considering Fractures Propagation

A Numerical Study on Long-Term Water Injection Procedure and the Corresponding Formation Property Variation

Injection-production optimization of carbonate reservoir based on an inter-well connectivity model

Research on Temperature–Pressure Coupling Model of Gas Storage Well during Injection Production

Transient Pressure Behavior of CBM Wells during the Injection Fall-Off Test Considering the Quadratic Pressure Gradient

Optimization Study of Injection-Production Parameters for CO2 Enhanced Oil Recovery and Storage in Low Permeability Oil Reservoirs

Maximizing efficiency and uniformity in SAGD steam circulation through effect of heat convection

Effect of Starting Pressure Gradient on the Production Performance of Fractured Wells

PERFORMANCE ANALYSIS OF THE INJECTION AND PRODUCTION WELLS IN UNDERGROUND NATURAL GAS STORAGE OF WATER-DRIVE GAS RESEVOIR TYPE

Investigation on water-drive performance of a fault-karst carbonate reservoir under different well patterns and injection-production modes based on 2D visualized physical models

Injection-production optimization of fault-karst reservoir—considering high-speed non-Darcy effect

Study on the Critical Production Calculation Method of the Water-Flooding Reservoir with Gas Cap

Numerical Simulation of Critical Production Pressure Drop of Injection and Production Wells in Gas Storage Based on Gas-Solid Coupling

The Coupling Study of Throttle and Reservoir Seepage of Water Injection in Development of Oil Field

Study on gas injection development effect of tight reservoir based on fluid occurrence state

Experimental Study on Improving Oil Recovery Mechanism of Injection–Production Coupling in Complex Fault-Block Reservoirs

Inter-well interferences and their influencing factors during water flooding in fractured-vuggy carbonate reservoirs

Integrated Design Technology of Geological Engineering for Pressure Flooding and Water Injection in Low Permeability Reservoirs: Take the Reservoir of Keshang Formation in Wu2 East Area as an Example