Abstract:It is known that the reaction rate of the thermal decomposition of polymer-bonded explosives exposed to cook-off has a certain relation with temperature, confining pressure and some other factors, which were verified by many experiments. Temperature-dominated thermal-decomposition models were developed for various high explosives and applied to study their decomposition process, such as HMX- and TATB-based polymer-bonded explosives. These models have reasonable accuracy. For example, the multistep thermal-decomposition model of PBX 9501 (which consists of 95% HMX, 2.5% Estane and 2.5% BDNPA/F) proposed by Tarver considers decomposition of both HMX and polymer binders. The temperature-dominated thermal-decomposition model only applies to preignition thermal decomposition. After ignition occurs, the dominant mechanism of the reaction transforms to deflagration and subsequent explosion, where the effect of pressure can no longer be neglected. Furthermore, the time scale of deflagration and explosion (millisecond or microsecond) differs significantly from the time scale of slow thermal decomposition (hours or minutes). The numerical model of postignition phenomenon (deflagration and final explosion) is still under investigation and is far from maturity. The predicted violence scale resulting from thermal explosion does not agree with experiment very well. An alternative method is to conduct a thermal–mechanical analysis for preignition stage, which takes advantage of a developed temperature-dominated thermal-decomposition model, and to analyze the stress caused by quasi-static thermal expansion. Herein, a thermal–mechanical analysis is implemented for a one-dimensional time-to-explosion experiment (ODTX) and a scaled thermal explosion experiment (STEX) with HMX-based polymer-bonded explosives inside using the finite element method. Then, the finite element model is applied to investigate the thermal decomposition of PBX 9501 inside an explosive device exposed to cook-off. The regions that have maximum temperature, maximum hydrostatic pressure and maximum von Mises stress are identified based on simulation results, which can benefit future improvement of the explosive device.

Research on Data Processing Algorithms for Two-factor Accelerated Storage Test of Initiating Explosives

Temperature and Humidity Accelerated Model and Modeling Technology of Initiating Device

Method of Determining the Critical Impact Velocity of Energetic Devices

Taguchi method-based evaluation of thermal hazard of lift-off pyrotechnics under various storage conditions

An Experiment Study on Mechanical Properties of Explosives as a Function of Tempersture and Strain Rate under Triaxial Compression

Testing and evaluation of the thermal damage caused by an explosion of energetic materials

A non-calorimetric approach for investigating the moisture-induced ageing of a pyrotechnic delay material using spectroscopies

A Calculation Instrument for the Sensitivity Test of Initiating Explosive Device

Experimental study of the dielectric properties of energy-containing materials at variable temperatures

Evaluation on thermal damage effects of single event solid fuel air explosive

EXPERIMENTAL MEASUREMENTS OF MECHANICAL PRESPONSE OF TNT AND SIMULATIVE EXPLOSIVES TO DYNA MIC COMPRESSION LOADING AND STUDIES OF THEIR CONSTITUTIVE RELATI ONSHIP

Numerical study of countermeasure against thermal stimuli for HMX-based polymer-bonded explosives

A Method of Computer Numerical Modeling of Mechanical Response of Energetic Materials to Confined Triaxial Dynamic Compression

The Application of Trend-line Analysis in Life Prediction of Initiating Explosive Device

Rapid identification of the consistency of failure mechanism for constant temperature stress accelerated testing

Meso-Simulation and Experimental Research on the Mechanical Behavior of an Energetic Explosive

Numerical Analysis of the Damage and Failure Behavior of Polymer-Bonded Explosives Using Discrete Element Method

Research on the Equivalent Impact Test Method for Different Pulse Widths Based on Micro-Electro-Mechanical System Devices

Numerical Study of PBX 9501 Explosive Combustion Process in Confined Space

Thermal–mechanical analysis for confined HMX-based polymer-bonded explosives

Design and Implementation of an Accelerating Rate Calorimeter Based on Modelica Modeling