Abstract:An optimized handling stability control strategy is put forward aiming at enhancing a four in-wheel independent-drive motors electric vehicle (4WIDEV) performance capable of handling and stability. The optimized control strategy is designed by a hierarchical control structure, which mainly includes vehicle motion controller and vehicle torque distribution controller. Lateral stability controller, in-vehicle motion controller, which yields the generalized force and generalized yaw moment required of the vehicle, is designed into two modes: an instability control mode and a continuous control mode, which mode is activated determining by stability judgment controller based on phase portraits of sideslip angle and yaw rate. When the vehicle state exceeds the stability envelope region, instability control mode based on envelope control is utilized by sliding mode control method, simultaneously controlling the two-vehicle states variables, whereas continuous control mode is performed with adaptive adjustment of the weight parameter according to pre-defined stability degree. The lateral stability controller with adaptive switching two modes exhibits excellent handling stability performance under normal driving conditions, especially under critical conditions, such as on low tire-road adhesion coefficient. The vehicle torque distribution controller assigns driving or regenerative braking torque to four wheels reasonably and efficiently to satisfy the generalized force and the generalize yaw moment acquired by the vehicle motion controller, which synchronously considers the motor output capability and tire friction ellipse constraints while maintains each wheel slip ratio within the stable range. The results in co-simulation experiments based on Carsim and MATLAB/Simulink verify the proposed control strategy, compared with other control strategies, and demonstrate the effective improvement 4WIDEV’s performance in terms of handling stability especially under critical conditions.

Development of XBW In-Wheel-motor-drive Electric Vehicle Simulation Platform

The Study on the Handling and Stability Test of Vehicles Based on ADMS and WTK

Study on Differential Assist Steering System with Double In-Wheel Motors with Intelligent Controller

Mechatronic model and simulation of four-wheel Mecanum vehicle driven by BLDC

Modular design and analysis of the x-by-wire center point steering independent suspension for in-wheel electric vehicle

Dynamic Stability Control Strategy Development for an In-Wheel Motorized Electric Vehicle

Vehicle Stability Control with Four-Wheel Independent Braking, Drive and Steering on In-Wheel Motor-Driven Electric Vehicles

Handling and Stabilities Calculation and Analysis of Automobile Steer by Wire System Driven by Graphic User Interface

Simulation of performance of 4WD electric vehicle

Integrated Yaw Stability Control of Electric Vehicle Equipped with Front/Rear Steer-by-Wire Systems and Four In-Wheel Motors

An Integrated Vibration Elimination System with Mechanical-Electrical-Magnetic Coupling Effects for In-Wheel-Motor-Driven Electric Vehicles

Decoupled Roll Stability Control of In-wheel Motor Drive Electric Vehicle

Optimized Handling Stability Control Strategy for a Four In-Wheel Motor Independent-Drive Electric Vehicle.

Research on Automobile SBW System and Correlative Technology

Comprehensive Optimization of Dynamics Performance and Energy Consumption for an Electric Vehicle Via Coordinated Control of Sbw and Fiwma

Dynamic Testing of In-Wheel Motor Based Electric Vehicle in Longitudinal Direction

System Identification and Modelling of Front Wheel Drive Electric Wheelchairs

Direct Yaw-Moment Control of Electric Vehicle With in-Wheel Motor Drive System

Development of an Electric All-Wheel-Drive Simulation Model Used to Test Torque Distribution Algorithms

Vertical vibration control of an in‐wheel motor‐driven electric vehicle using an in‐wheel active vibration system

A Steering Wheel System and Controller for the Driving Simulator