Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Investigation of Macro-fin Structure on Heat Transfer Performance of Close-Loop R410A Flashing Spray Cooling

Experimental Investigation of Spray Cooling Performance in Non‐boiling Zone on Rough Superhydrophilic/hydrophobic Surfaces

Enhancement of Heat Transfer on Micro- and Macro- Structural Surfaces in Close-Loop R410A Flashing Spray Cooling System for Heat Dissipation of High-Power Electronics

Heat Transfer Enhancement Due to Surface Modification in the Close-Loop R410A Flash Evaporation Spray Cooling

Coupling dynamic thermal analysis and surface modification to enhance heat dissipation of R410A spray cooling for high-power electronics

Parametric Investigation on the Close-Loop R410A Flash Spray System for High Power Electronics Cooling under Low Temperature

Heat Transfer Performance and Optimization of a Close-Loop R410A Flash Evaporation Spray Cooling

Experimental Investigation of Spray Cooling System in a Closed Loop Based on Refrigeration Cycle

Experimental Investigation on Heat Transfer Characteristics of R1336mzz Flash Spray Cooling

Experimental Study on a Spray and Falling-Film Cooling System

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Dynamic thermal management of flashing spray cooling by the frequency conversion of compressor

Heat Transfer Optimization of R134a Phase Change Spray Cooling in a Closed Loop System

Experimental study on large cooling load phase change spray cooling

Study on Moving Nozzle Effects on Spray Cooling of Electronics

Numerical Investigations of the Cooling Performance of an R410A Closed-Loop Spray Cooling System

Experimental study on the characteristics of a closed loop R134-a spray cooling

Experimental study of dielectric liquid spray cooling on multi-scale structured surfaces inspired by leaf veins

Experimental Study on Phase Change Spray Cooling

Experimental Study on Heat Transfer Performance of a Novel Compact Spray Cooling Module

Experimental investigation on the macroscopic spray and microscopic droplet diameter, velocity and temperature of R404A flashing spray