Visualization and Location Determination of Pit Initiation Sites in Martensitic Stainless Steel during Corrosion-Fatigue Cyclic Plastic Deformation
Robert Lacasse,Christophe Hitz,Pierre-Antony Deschênes,Isabelle Montplaisir,Lydia Damphousse,Alexandre Lapointe,Carlo Baillargeon,Lindsay Grandy,Janine Mauzeroll
DOI: https://doi.org/10.1149/ma2023-02141138mtgabs
2023-12-22
ECS Meeting Abstracts
Abstract:Low-carbon martensitic stainless steels, such as 13%Cr4%Ni, are widely used in manufacturing hydraulic turbine runners. High tensile strength steel, such as cast CA6NM or wrought S41500 martensitic stainless steel, has an acceptable resistance to corrosion and cavitation, and reduces the weight and cost while offering a more efficient design. During operation, the combined effect of cyclic loading (fatigue) and corrosion reduces the fatigue strength and can initiate cracks at localized corrosion surface defects. In this study, we determined the bulk and localized corrosion behavior of wrought (S41500) and cast (CA6NM) 13%Cr4%Ni stainless steel before and after plastic deformation. Susceptibility to pitting corrosion was studied using open circuit potential and potentiodynamic polarization measurements in 0.020 M NaCl. Localized corrosion behavior was studied using a scanning droplet cell (SDC) and oil immersed scanning electrochemical cell microscopy (OI-SECCM). The bulk and localized electrochemical measurements after different surface preparation methods (mechanical polishing, followed by etching or electro-etching in different media) were compared. The surface defects including micro-voids and inclusions of different types were characterized. The location of pit initiation was then determined using scanning electron microscopy and profilometry imaging. A three-electrode microcell with a working electrode of 1 mm2 was designed and hyphenated with optical microscope to allow in situ tracking of pit initiation and growth. Chronopotentiometry and chronoamperometry controlled pit initiation, while optical microscopy demonstrated dynamic release of corrosion products and measured oxide repassivation kinetics. Finally, the in situ technique was developed further to include a microtensiometer fatigue apparatus to study the synergy effect between corrosion and fatigue. Location of pit initiation was compared with and without plastic deformation. Videos of pit initiation and growth will be presented.