Abstract:High precision time-of-flight (TOF) measurements in modern high-energy physics experiments have often a high demand to measure both pulse timing and pulse width at the same time. The pulse width from such TOF detectors can be as narrow as 1 ns, which poses great challenges to current design of time-to-digital converters (TDCs) based on field programmable gate array (FPGA). In this paper, we propose a novel FPGA-based TDC design which can measure nuclear signals with extremely narrow pulse width outputting timestamps for both the rising edge and falling edge simultaneously. The discriminated digital signal with both timings from the rising edge and falling edge is directly transmitted along the tapped-delay-line (TDL) of the TDC. Relying on the proposed powerful and efficient encoding logic, the two timestamps are precisely extracted out from the TDL status in one time of measurement. The TDC measurement dead time is only two system clock cycle, and the minimum measurable pulse width is only limited by the performance of LVDS receiver of FPGA, which was tested as low as 400 ps in our case of implementing the TDC in a Virtex Ultrascale+ FPGA. Using one TDC channels to measure given pulse width, the RMS precision is evaluated as 3.0 ps. Given the pulse widths ranging from 0.4 ns to 1.5 ns, the measured pulse width by the TDC is highly consistent with the readout values from the oscilloscope. In addition to the excellent performance, compared with previous TDC designs for pulse width measurement, the structure of the proposed TDC is much compact with low logic resource consumption, which is very helpful for multi-channel integration in high-energy physics experiments.

A Multichannel High-Precision Pulse Counting System Based on FPGA

Picosecond Counting Design Based on FPGA

Design and Realization of High Precision Time Interval Measurement Peripheral Circuit Based on FPGA

A high-speed and 8-channel counter based on FPGA

A nanosecond level measurement method of pulse width based on FPGA

A 128-Channel, 710 M Samples/Second, and Less Than 10 Ps RMS Resolution Time-to-Digital Converter Implemented in a Kintex-7 FPGA

An FPGA-Based High Precision Pulse Width Measurement Time-to-Digital Converter with Dual-TDL Multiplexer Encoder

High-precision time measurement electronics using the bandpass sampling method

Time Measurement Circuit System Design

Design and Realization of High Precision Time-interval Measurement Based on FPGA

A Low-Cost FPGA-Based Coarse-Fine Counting Time-to-Digital Converter With External High-Precision Reference Clock

A Flexible 32-Channel Time-To-Digital Converter Implemented in A Xilinx Zynq-7000 Field Programmable Gate Array

FPGA‐based High Accuracy Burst Carrier Frequency Measurement Method

High-Resolution, Multi-Channel FPGA-Based Time-to-Digital Converter

Design and Implementation of A Time to Digital Convertor Circuit Based on Field-Programmable-Gate-Array in Positioning System

An FPGA-based, High-Precision, Narrow Pulse Width Measurement Time-to-digital Converter

Low-cost FPGA-based multi-channel TDC with high resolution and density for time-of-flight detectors

FPGA Vernier Digital-to-Time Converter With 1.58 ps Resolution and 59.3 Minutes Operation Range

A Combination of Multiple Channels of FPGA Based Time-to-digital Converter for High Time Precision

Real-time Energy Measurement of High Repetition Rate Ultrashort Laser Pulses Using Pulse Integration and FPGA Processing.

Design of Real-Time Pulse Parameter Measurement System Based on FPGA