Abstract:This study establishes detailed neural network modeling procedures for the combustion optimization of a power generation unit, equipped with a Selective Catalytic Reduction (SCR) system. In particular, artificial intelligence neural networks were applied due to its capability in treating large pools of data of great nonlinearity. The objective of this study was to reduce nitrogen oxide (NOx) emissions in the stack gas, lower the cost of emissions compliance and minimize the net unit heat rate at this power generation unit at full-load conditions. These procedures include building a database with real coal power plant operating data, modeling the database and using the genetic algorithm to optimize the operating conditions. The operation is optimized with respect to the steam temperature, selective catalyst reactor, and separated over-fire air conditions. Verifications of the results demonstrated that by carrying out the reported study, the pollutant concentrations of the boiler are significantly decreased and the catalyst layer is effectively preserved, while the operation can be maintained stable near the full-load condition. It was found that the average ammonia (NH3) flow to the SCR under optimized conditions was 229 kg/h, while the average NH3 flow under non-optimal operational conditions was 260 kg/h, resulting in a reduction in NH3 consumption of approximately 12 % from the non-optimized operational condition. In the meantime, the SCR inlet (boiler exit) NOx was reduced from 523 mg/Nm3 (non-optimized operational condition) to 444 mg/Nm3 (optimized operational condition), which represent about 15 % reduction. Based on the experience with SCR from manufactures and operators, the SCR catalyst life expectancy has a direct relationship with the SCR inlet NOx concentration and NH3 injection rate. The lower the NOx concentration at the SCR inlet and the less the NH3 injection rate, the longer of the SCR catalyst life will be. Thus, it is expected that the SCR catalyst layer replacement frequency could be reduced by 10 to 20 % over the normal catalyst replacement cycle, while meeting the same environmental NOx emissions limit. Additionally, a Delta Heat Rate was also calculated using best available data from the optimized operational conditions, including boiler load, boiler excess oxygen (O2), fly ash unburned carbon and attemperation flow. Results were compared with the average Delta Heat Rate calculated from baseline tests. It was found that the average Delta Heat Rate from baseline tests are −60 kJ/kWh, while the delta heat rate from the optimized operation condition hours is −118 kJ/kWh. This represents about 0.57 % improvement on unit heat rate from the baseline average.

RES Induced for Combustion Optimized Control and Low NO<Subscript><Emphasis Type="Italic">x</Emphasis></Subscript> Emission in Thermal Power Generating Units

Predictive Control and Economic Performance Optimization of CFBB Combustion Process

Unit Load and Combustion Control Optimization Based on Radiation Energy Signals

A Review of Control Technologies of Combustion Optimization in Utility Boilers

Design and Realization of Combustion Control Strategy for Industrial Boilers under JX-300XP DCS

TECHNOLOGIES OF NO_X EMISSION CONTROL FOR COAL-FIRED POWER PLANTS

Optimization of Circulating Fluidized Bed Boiler Combustion Key Control Parameters Based on Machine Learning

Investigation of NOx emission under different burner structures with the optimized combustion model

Application Research of Combustion System for Medium and Small Sized Boilers

Research of an Adjustive System of Boiler Combustion Based on the Radiant Energy

Collaborative optimization of energy conversion and NOx removal in boiler cold-end of coal-fired power plants based on waste heat recovery of flue gas and sensible heat utilization of extraction steam

Enhancement of SCR denitrification control strategy considering fluegas temperature fluctuation: Fundamental principle and performance evaluation

A Study of the Optimization System of Radiation Energy Detection-based Intelligent Combustion Evolution

Application of an Improved State Feedback Control in the Selective Catalytic Reduction Denitrification Systems of Coal Power Units Under Variable Load Conditions

A new on-line combustion optimization approach for ultra-supercritical coal-fired boiler to improve boiler efficiency, reduce NOx emission and enhance operating safety

Insight into the regulation effect of steam dilution on oxygen-enriched ammonia combustion characteristics

Combustion optimization of a coal-fired power plant boiler using artificial intelligence neural networks

Experimental Investigation of Operating Strategy of Low NOx, High Efficiency Coal-Fired Utility Boilers

CFD modeling of hydrodynamics, combustion and NOx emission in a tangentially fired pulverized-coal boiler at low load operating conditions

Low NOx combustion and SCR flow field optimization in a low volatile coal fired boiler