Insight into the regulation effect of steam dilution on oxygen-enriched ammonia combustion characteristics

Yu Zhang,Bo Han,Xincheng Li,Wenda Zhang,Linyao Zhang,Yijun Zhao,Shaozeng Sun
DOI: https://doi.org/10.1016/j.fuel.2024.131832
IF: 7.4
2024-05-08
Fuel
Abstract:NH 3 /O 2 /H 2 O combustion technology combines oxygen enrichment to enhance NH 3 combustion and steam dilution to control flame temperature and emissions, which can achieve clean and efficient power generation. Steam dilution strategies necessitate a balance between flame speed, temperature, and emissions. The key lies in kinetic investigation into the regulation effects of steam dilution on NH 3 /O 2 /H 2 O flames. An adaptive kinetic model is developed and validated against the measured flame speed and NO distribution. Experimental and numerical investigations are conducted to analyze the steam dilution effect on NH 3 /O 2 /H 2 O flame at varying Φ s and T u s. Fuel-lean NH 3 /O 2 /H 2 O flames ( Φ = 0.8–0.9) possess the highest flame speeds and a 25 % steam dilution results in a 39–45 % reduction (67.63–82.09 cm/s) in S L . H/O radical pools and NH 3 primary decomposition (NH 3 → NH 2 + H) are the keys to the S L , and steam dilution significantly decreases the key radical accumulation. As Z H2O increases from 0 to 0.25, the stoichiometric flame temperature decreases to approximately 2600 K (a reduction of about 200 K). The staged dehydrogenation of NH 3 always dominates the heat release, while the conversions of the H/O radical pool are the main endothermic reactions ·H 2 O dilution reduces the reactant concentration, and the high specific heat capacity of H 2 O also further reduces the flame temperature. Z H2O of 0.25 can reduce NO emissions to the order of magnitude of 100, while steam dilution may turn to promote NO emissions at Φ < 0.75 because steam dilution accelerates the generation of H and OH and promotes NO formation at fuel-lean conditions. Z H2O needs to be increased to more than 30 %, controlling the flame temperature not to exceed 2000 K and improving the fluid work efficiency. To further reduce NO emissions to 50 ppmv@15 %O 2 , it is necessary to adopt staged combustion nozzle/chamber structure designs, such as co-flow or secondary injection.
energy & fuels,engineering, chemical
What problem does this paper attempt to address?