Abstract:Traditionally, a resistive pulse sensor (also known as Coulter counter) works by letting a particle pass through a small orifice in an electrolyte solution. The detection sensitivity mainly relies on the volume ratio of the particle to the orifice. This paper presents a novel resistive pulse sensor which has a sensing orifice located on the side wall of a microchannel. In this way, the sensor can detect and count particles (or cells) without requiring particles (or cells) passing through the sensing gate. An equation was derived to relate the magnitudes of the detected signals and the electrical resistances. Results show that the magnitudes of the detected signals can be increased by applying voltages from more than one voltage input channels simultaneously. Under the same conditions, the magnitudes of the detected signals become larger when the diameters of particles are larger. Higher detection sensitivity can be obtained simply by increasing either the magnitudes of the applied voltages or the number of the voltage input channels, or reducing the opening of the side sensing gate to a size that is even smaller than the diameter of the particle. Due to the high detection sensitivity, detection of 1 μm particles by a relatively large sensing gate of 5 × 10 × 10 μm (width × length × height) was successfully demonstrated with a signal to noise ratio (S/N) of approximately 3. This sensor was also applied to detect and count human red blood cells and lymphocyte cells. Results show that this method can clearly distinguish the cells with different sizes based on the pre-determined-thresholds. Because this sensor does not require cells to pass through the sensing gate, the channel clogging problem can be avoided. More importantly, the detection sensitivity can be tuned by applying different voltages without fabricating a smaller sensing gate.

(Invited) Automatic Particle and Cell Detection and Manipulation in a Microfluidic Chip

An optical nanofibre-enabled on-chip single-nanoparticle sensor

Automatic Particle Detection and Sorting in an Electrokinetic Microfluidic Chip.

Size‐based Cell Sorting with a Resistive Pulse Sensor and an Electromagnetic Pump in a Microfluidic Chip

Detection and Sizing of Nanoparticles and DNA on PDMS Nanofluidic Chips Based on Differential Resistive Pulse Sensing.

Automatic Single-cell Manipulation in an Electrokinetic Microfluidic Chip

Particle Detection on Microfluidic Chips by Differential Resistive Pulse Sensing (RPS) Method.

Design and Performance of a Microfluidic Particle Sorting Device

Improving Particle Detection Sensitivity of a Microfluidic Resistive Pulse Sensor by a Novel Electrokinetic Flow Focusing Method

High-speed discrimination and sorting of sub-micron particles using a microfluidic device

Automatic and Selective Single Cell Manipulation in A Pressure-Driven Microfluidic Lab-On-Chip Device

Enhanced cell sorting and manipulation with combined optical tweezer and microfluidic chip technologies.

Nanoparticle Detection by Microfluidic Resistive Pulse Sensor with Optical Evidence

Sequential Dielectrophoresis Particle Separation and Resistive Pulse Detection in an Electrokinetic Microfluidic Chip

High-throughput multi-gate microfluidic resistive pulse sensing for biological nanoparticle detection

Automated Raman Based Cell Sorting With 3d Microfluidics

Nanoparticle Detection by Microfluidic Resistive Pulse Sensor with a Submicron Sensing Gate and Dual Detecting Channels-Two Stage Differential Amplifier

Microfluidic and Nanofluidic Resistive Pulse Sensing: A Review

A Novel Microfluidic Resistive Pulse Sensor with Multiple Voltage Input Channels and a Side Sensing Gate for Particle and Cell Detection.

Integrated In-Plane Nanofluidic Devices for Resistive-Pulse Sensing

Toward the Detection of Single Cell Releasing Through High Efficient Chip-Based Nano Fluidic Systems.