Abstract:BackgroundDue to the complex structure of the ventilation ducts in nuclear facilities, the concentration distribution of radionuclides such as aerosols in the ducts is uneven. The inhomogeneity of aerosol distribution brings great challenges to the sampling representativeness of radiation monitoring. In chemical processes, static stirring devices are commonly used to enhance the homogeneity of the product mix. However, this device has not been applied in the nuclear power field.PurposeAccordingly, this study aims to improve the mixing uniformity of aerosols in air supply pipelines by using static stirring devices, so as to provide a reference for the representativeness of radiation monitoring sampling.MethodsThe stirring effects of three different stirring devices were investigated through numerical simulations. The RNG k-ε model was used to simulate the gas phase flow field, and the discrete phase model (DPM) was employed in ANSYS CFX software to simulate the behavior of aerosol particles. Selection of the particle size of aerosols followed the recommendations in the sampling representative standards, with the specific size of 10 μm. The other boundary conditions in the simulation were based on the actual operating conditions of a nuclear power plant. As a result, the effects of different stirring devices on the flow field and aerosol concentration distribution were obtained.ResultsThe static stirring device can form strong swirls, thereby improving the uniformity of aerosol distribution. Increasing the twist angle of the blades and the proportion area of the inner blades strengthened the generated vortex field, further affecting the diffusion of aerosols. The static stirring device with an increased inner blade area exhibited a moderate swirl intensity, and better stirring effect than those of the other two structures. The coefficient of variation of the aerosol concentration decreased by 30.60%.ConclusionsInstalling a static stirring device in an air supply duct is a feasible method to improve the mixing uniformity of aerosols. Owing to the complex structure of ventilation ducts in nuclear facilities, the concentration distribution of radionuclides, such as aerosols, in the ducts is uneven. This inhomogeneous aerosol distribution poses significant challenges to the sampling representativeness of radiation monitoring. In chemical processes, static stirring devices are commonly used to enhance the homogeneity of the product mix. However, these devices have not yet been applied in the field of nuclear power.

Study on the applying oscillating airfoil in the active wind tunnel to reproduce the natural wind turbulence for the nuclear power plant site

Design and Experimental Research of Multi-fan Wind Tunnel for Atmospheric Diffusion in Nuclear Accident

A new atmospheric boundary layer wind tunnel simulation methodology for wind effects on large cooling towers considering wind environment variations

Adaptive wind tunnel model tests for a large cooling tower considering the realistic wind environment *

3D Numerical Simulation of Radionuclides Atmospheric Dispersion in Chinese Nuclear Safety Regulation

Enhanced Air Dispersion Modelling at a Typical Chinese Nuclear Power Plant Site: Coupling RIMPUFF with Two Advanced Diagnostic Wind Models.

ICONE23-1277 INVESTIGATION OF THE INFLUENCE OF TURBULENCE MODELS ON THE SIMULATION OF THE GAS DISTRIBUTION

A New Research Scheme for Full-Scale/Model Test Comparison of Wind Effects on Pengcheng Cooling Tower Based on Sinusoidal Flow Field Simulations

DEVELOPMENT OF A DATA-DRIVEN TURBULENCE MODEL FOR THERMAL STRATIFICATION ANALYSIS IN REACTOR SYSTEM

Research of 3d numerical wind tunnel technology used in radiation environmental impact assessment of small modular reactor

Study on Aerosol Thermophoretic Force and Thermophoresis Deposition Model in Reactor Building

CFD Simulation of Spray Test in the Small-sized Nuclear Containment

Wind Tunnel Validation Study of Joint Estimation Source Term Inversion Method

Computational Fluid Dynamics-Aided Simulation of Twisted Wind Flows in Boundary Layer Wind Tunnel

CFD evaluation of turbulence models for flow simulation of the fuel rod bundle with a spacer assembly

Micro-SWIFT SPRAY modeling of atmospheric dispersion around a nuclear power plant site with complex topography

A CFD study on radionuclides diffusion and dose assessment in Daya Bay nuclear power plant

Numerical Study of the Dynamic Response of the Natural Draft Dry Cooling Tower under Crosswind Condition

Numerical analysis of effect of static stirring device on mixing uniformity of aerosol in the air duct of a nuclear facility

High-Resolution Simulation of the Near-Field Pollutant Dispersion in a Nuclear Power Plant Community with High-Performance Computing

Numerical simulation of flow field characteristics and pollutant transport under different ventilation modes