Abstract:The failure issue of electromagnetic railgun rails is a widely researched problem, but effective research methods are lacking in studying the microstructure of rail materials. The high current and high strain rate tensile (HCHST) testing platform was designed to simulate the high current density and high strain rate deformation service conditions of pure copper rails used in electromagnetic guns. The microstructural and mechanical properties of commercially pure copper were analyzed using TEM and EBSD under high current density (2680 A/mm 2 ) and various high strain rates ( ε̇=3404s−1 , ε̇=6808s−1 )using the HCHST test platform. The obtained results were then compared with those obtained from the as-received state and the quasi-static current-assisted tensile (QCAT) test. The findings indicate that the deformation mechanism of pure copper specimen under HCHST is similar to that of QCAT, where dislocation and slip are the main mechanisms. However, distinct differences in microstructure were observed. Specifically, a significant number of dislocation walls were present in the grains under QCAT, whereas numerous dislocation cells were formed in the grains under HCHST. In the high-current density environment of 2680 A/mm 2 , as the strain rate increased, the number of dislocation cells increased while their size decreased. The grains became extremely refined, and the KAM value also increased. Furthermore, the Vickers hardness of pure copper significantly improved after undergoing the HCHST. Based on the experimental findings, it was observed that during the service process of the pure copper rail in electromagnetic railguns (under the influence of high current density and high strain rate deformation), the surface of the rail material experienced significant dislocation entanglement. This resulted in a significant increase in the strength and hardness of the surface of the rail with high strain rate deformation. However, the uneven distribution of strength and hardness throughout the surface layer of the rail eventually made it more susceptible to deformation and failure.

Multiform Damages on the Rail of an Electromagnetic Rail Launcher

Design and Experimental Research of Ultra-High-Speed Electromagnetic Rail Launch Device

Research Progress on Surface Damage and Protection Strategies of Armature–Rail Friction Pair Materials for Electromagnetic Rail Launch

Research progress on advanced rail materials for electromagnetic railgun technology

Interior Ballistic Characteristics of Electromagnetic Rail Launcher Under Continuous Firing

A Multi-Field Coupling Model for the Magnetic-Thermal-structural Analysis in the Electromagnetic Rail Launch

Investigation on the microstructure evolution and mechanical properties of electromagnetic rail material in a launch environment

Dynamic Analysis of Integrated Launch Package in the Barrel of Railgun

Research on the Damage Diagnosis for Rails with a New 3D Scanning Method

In-Bore Dynamic Measurement and Mechanism Analysis of Multi-Physics Environment for Electromagnetic Railguns

Evaluation of a Superconducting Augmented Rail-Type Electromagnetic Launch System

Testing the Spalling Defects on Rail Tread with Laser EMAT Ultrasonic

Electromechanical Performance of Rails With Different Cross-Sectional Shapes in Railgun

Dynamic response of electromagnetic railgun under time-dependent electromagnetic moving loads

Research on Energy Loss Distribution of an Augmented Railgun

A damage detection system for inner bore of electromagnetic railgun launcher based on deep learning and computer vision

A Review of the Computational Investigation of Three-Dimensional Transient Magneto-Thermal Coupling Characteristics of Electromagnetic Railgun Armature and Rail in High-Speed Sliding Electrical Contact

Experimental Study of Static and Dynamic Loading Effects on Guided Wave-Based Intelligent Monitoring of Welded Rail Joints

Research on the rail waist defect testing with laser-EMAT ultrasonic and signal processing

3D numerical research of railgun gouging mechanism based on material point method

A Novel Magnetic Coupled Railgun System Based on Inductive Pulsed Power Supply—Preliminary Theoretical Analysis and Experiment Study