Abstract:The purpose of this article is to analyze the front door coupling effect that may occur in the projectile receiver due to the discharge pulse radiation in electromagnetic railguns, and to simulate the discharge pulse interference. This phenomenon will have an impact on the launch of the projectile, causing its fuse to be disturbed, ultimately affecting the weapon performance of the electromagnetic railgun. Discharge refers to when the armature carrying the projectile is fired out of the chamber, and the armature connected between the two rails detaches, causing a circuit break in the electrical circuit during the operation of the electromagnetic railgun. The current flowing through the armature is disturbed, causing an instantaneous high voltage to penetrate the air gap between the two rails, generating nanosecond pulse width discharge voltage pulse radiation, with a spectrum of up to tens of megahertz. In this paper, we establish a receiving antenna model on the projectile, which is essentially a horn antenna, receiving electromagnetic pulses from the discharge process, and coupling the pulse interference through its front door. During the analysis and calculation, we established an antenna receiver model located in the C-band with a frequency of 6 GHz for simulation, analyzed and calculated the actual interference loaded on the projectile after front door coupling, and verified the correctness of the simulation settings and results by comparing with the literature. Finally, we found that because the main energy spectrum of the pulse is at MHz level, when the front door of the C-band horn antenna is coupled, the standing wave ratio of the antenna is very large and the gain is very small, so the pulse interference is filtered, which can make the interference finally loaded on the projectile insufficient to affect the normal operation of the projectile. At the same time, it is recommended to add an RF filter to the receiving channel to further enhance anti-interference ability, so as to ultimately enable the electromagnetic railgun to function properly.

Research on Energy Loss Distribution of an Augmented Railgun

Analysis of sliding electric contact characteristics in augmented railgun based on the combination of contact resistance and sliding friction coefficient

Research on Interior Ballistic Mechanics of Electromagnetic Railgun

Evaluation of a Superconducting Augmented Rail-Type Electromagnetic Launch System

Interior Ballistic Characteristics of Electromagnetic Rail Launcher Under Continuous Firing

Research on Segmentation Evaluation Model of Sliding Electrical Contact Performance of Electromagnetic Railgun

Study on the Lumped Evaluation Model of Sliding Electrical Contact Performance of Railgun

Design and Experimental Research of Ultra-High-Speed Electromagnetic Rail Launch Device

Modeling and simulation of muzzle flow field of railgun with metal vapor and arc

Research on Arc Suppression Parameter Matching of Augmented Electromagnetic Launcher

Energy Conversion Efficiency of Electromagnetic Launcher with Capacitor-Based Pulsed Power System

A Review of the Computational Investigation of Three-Dimensional Transient Magneto-Thermal Coupling Characteristics of Electromagnetic Railgun Armature and Rail in High-Speed Sliding Electrical Contact

Research progress on advanced rail materials for electromagnetic railgun technology

Researches on the System Launch Efficiency and the Armature Muzzle Kinetic Energy of a Constructed Electromagnetic Railgun

Investigation of the Distribution Problem in the Operating State of an Electromagnetic Railgun: Radio Fuse Disturbance, Field Characteristics, and Susceptible

Finite Element Analysis of Current Density Distribution in the Sliding Contact Interface of Electromagnetic Railguns: A Literature Review

Dynamic response of electromagnetic railgun under time-dependent electromagnetic moving loads

In-Bore Dynamic Measurement and Mechanism Analysis of Multi-Physics Environment for Electromagnetic Railguns

Analysis of the Research Progress of Electromagnetic Railgun Based on CiteSpace

Multiform Damages on the Rail of an Electromagnetic Rail Launcher

Finite Element-Boundary Element Method Based Simulations of Electromagnetic Railgun in Augmented Configurations