Abstract:The reasonable and rapid prediction of turbine performance based on design targets such as mass flow rate and pressure ratio is indispensable in the preliminary and conceptual design stage for gas turbine engines in the aviation and power generation industry. However, the lack of detailed geometrical and aerodynamic parameters in this stage significantly challenges the reasonable evaluation of turbine characteristics. The present work proposes a rapid prediction method of axial turbine performance by coupling the inverse design and direct analysis. Firstly, according to the one-dimensional mean line design theory with empirical loss and deviation correlation models, the basic aerodynamic and geometrical parameters are quickly obtained by solving the inverse problem to fulfill the design targets such as mass flow rate and pressure ratio with optimized efficiency. Then, by adopting the loss and deviation correlation models in the off-design conditions, the turbine characteristics in a wide range of operating conditions are obtained by solving the direct analysis problem. Thus, the reasonable and rapid prediction of the turbine characteristics can be realized by coupling the inverse design with direct analysis. Based on the built prediction model, the effect of various deviation models on the predicted turbine characteristics, which was not systematically investigated in previous studies, is clarified by comparing the predicted performance with published test results. Finally, an optimization method of the empirical coefficients in turbine loss and deviation models based on the Genetic Algorithm (GA) is introduced. This method employs optimization theory and existing experimental data to improve the prediction accuracy. The results show that the averaged prediction discrepancies of output powers and mass flow rates in a wide range of operating conditions are no more than 2% and 2.5% for test cases after the optimization of model coefficients. Therefore, this optimization method is expected to be used for updating the empirical coefficients to improve the model prediction accuracy, accompanying the evolution of turbine design strategy at present or in the future.

Triaxial Gas Turbine Performance Analysis for Variable Power Turbine Inlet Guide Vane Control Law Optimization

High-power Mode Control for Triaxial Gas Turbines with Variable Power Turbine Guide Vanes

Effects of inlet turbulence intensity on wall heat transfer in a turbine guide vane

Towards Predictive Maintenance of a Heavy-Duty Gas Turbine A New Hybrid Intelligent Methodology for Performance Simulation

Fast Multi-Objective Optimization Design of Gas Turbine L-inlet Duct

Dynamic Real-Time Simulation of Triaxial Marine Gas Turbine with Variable Power Turbine Guide Vane

Development and Application of A Thermodynamic-Cycle Performance Analysis Method of A Three-Shaft Gas Turbine

Numerical research on the aerodynamic performance of inlet volute duct for a heavy-duty gas turbine

Performance Calculation Of A Three-Shaft Gas Turbine: Experiment Evaluation And Analysis

Real-Time Variable Geometry Triaxial Gas Turbine Model for Hardware-in-the-Loop Simulation Experiments

Identification of nonparametric thermodynamic model and optimization of ocean thermal energy conversion radial inflow turbine

Modeling and Performance Analysis of a Dual-Shaft Counter-Rotating Gas Turbine

Performance analysis and optimized control strategy for a three-shaft, recuperated gas turbine with power turbine variable area nozzle

Rapid Performance Prediction Model of Axial Turbine with Coupling One-Dimensional Inverse Design and Direct Analysis

Multi-objective performance optimization and control for gas turbine Part-load operation Energy-saving and NOx emission reduction

Numerical Simulation and Aerodynamic Optimization of Two-Stage Axial High-Pressure Turbine Blades

Numerical Investigation of Guide Vane Hydraulic Torque Characteristics of a Pump Turbine in Pump Mode

Improvement of Part-Load Performance of Gas Turbine by Adjusting Compressor Inlet Air Temperature and IGV Opening

Modeling and Simulation of Aero-Derivative Gas Turbine for Power Generation

Optimization design of radial inflow turbine combined with mean-line model and CFD analysis for geothermal power generation

Optimization of Guide Vane Airfoil Shape of Pump Turbine Based on SVM-MDMR Model