Abstract:Al(OH)3/Co(OH)2 shows promise for 5‐hydroxymethylfurfural (HMF) conversion to 2,5‐furandicarboxylic acid (FDCA) through the synergistic effect of active and adsorption sites. Experimental results reveal that Al(OH)3 shows a strong absorption ability, contributing to the enrichment of HMF on the surface of the catalyst. Meanwhile, Co3+ as active sites further accelerated the catalytic kinetics. Electrocatalytic conversion of biomass‐derived 5‐hydroxymethylfurfural (HMF) to value‐added 2,5‐furandicarboxylic acid (FDCA) is of great significance in compensating for the rapid consumption of fossil resources. However, it is a challenge to further improve the performance of HMF electrocatalytic oxidation (HMFOR) by synergistic kinetics (active sites) and thermodynamics (adsorption sites). In this work, Al(OH)3/Co(OH)2 is successfully fabricated as an efficient catalyst, and its catalytic mechanism for HMF oxidation is clarified. Extended X‐ray absorption fine structure (EXAFS) analysis demonstrate that electrochemically generated Co3+ is the main catalytic site for HMF oxidation. The HMF equilibrium adsorption capacity of Al(OH)3 reach 57.0 mg g−1, which effectively increase the initial concentration of substrate and promoted the reaction rate. The combined results, based on 24 stable cycles and an FDCA yield retention rate of 98.6% after 180 days, are the highest ever achieved. Additionally, it is shown that this system can oxidize four other biomass‐derived substrates. Therefore, this work provides insight into a hydroxide catalyst that owes its efficiency to synergy between active and adsorption sites.

The effect of potassium on Cu/Al<sub>2</sub>O<sub>3</sub> catalysts for the hydrogenation of 5-hydroxymethylfurfural to 2,5-bis(hydroxymethyl)furan in a fixed-bed reactor

CuZnCoOx Multifunctional Catalyst for in Situ Hydrogenation of 5-Hydroxymethylfurfural with Ethanol As Hydrogen Carrier

Catalytic in-situ hydrogenation of 5-hydroxymethylfurfural to 2,5-dimethylfuran over Cu-based catalysts with methanol as a hydrogen donor

Catalytic in Situ Hydrogenation of Fatty Acids into Fatty Alcohols over Cu-Based Catalysts with Methanol in Hydrothermal Media

Efficient catalytic transfer hydrogenation of furfural to furfuryl alcohol in near-critical isopropanol over Cu/MgO-Al2O3 catalyst

Catalytic Transfer Hydrogenation of Furfural to Furfuryl Alcohol by Cu-Pd/Al2O3 in Near-Critical Isopropanol

Facile One-Pot Synthesis of Functional Hydrochar Catalyst for Biomass Valorization

Effect of potassium on the MnOx/γ-Al2O 3 catalysts for hydrogenation of methyl benzoate

Effect of potassium on the MnOx/gamma-Al2O3 catalysts for hydrogenation of methyl benzoate

Cu-based Catalysts for Hydrogenation of 5-Hydroxymethylfurfural: Understanding of the Coordination Between Copper and Alkali/alkaline Earth Additives

Optimization and reaction kinetics of catalytic transfer hydrogenation of 5‐hydroxymethylfurfural to 2, 5‐dimethylfuran over CuCoOx catalysts

Effect of Potassium on the Regulation of C1 Intermediates in Isobutyl Alcohol Synthesis from Syngas over CuLaZrO2 Catalysts

Promotion effect of Fe–Cu catalyst for the hydrogenation of CO2 and application to slurry reactor

Synergistic effect of surface Cu0 and Cu+ species over hydrotalcite-derived Cu Co3-AlO mixed-metal oxides toward efficient hydrogenation of furfural to furfuryl alcohol

Effect of Calcination Atmosphere on the Performance of Cu/Al2O3 Catalyst for the Selective Hydrogenation of Furfural to Furfuryl Alcohol

Highly efficient Cu-based catalysts for selective hydrogenation of furfural: A key role of copper carbide

Adsorption–Activation Bifunctional Center of Al/Co‐Base Catalyst for Boosting 5‐Hydroxymethylfurfural Oxidation

Unveiling the promoting effect of potassium on the structural evolution of iron catalysts during CO 2 hydrogenation

The effect of potassium on the balance of metal-acid sites in Pt/Al2O3 catalysts and its n-hexane dehydrogenation performance

Importance of Magnesium in Cu-Based Catalysts for Selective Conversion of Biomass-Derived Furan Compounds to Diols

Effects of preparation variables on an alumina-supported FeCuK Fischer–Tropsch catalyst