Abstract:This paper presents a novel exoskeleton robot that can be used at home to rehabilitate the index fingers of stroke-affected patients. This exoskeleton is designed as a one-degree-of-freedom four-bar mechanism able to guide the human index finger to perform a finger curl exercise motion. The proposed device is the only lateral, stand-alone mechanism built to date that can carry the weight of the human hand, thus making the user free from wearing it. The design starts by tracing the trajectory of the index finger using 'Angulus' software. 'SALAR Mechanism Synthesizer' software is used for dimensional synthesis of the four-bar mechanism. Using additive manufacturing technology, a prototype of the proposed device is developed. Static force analysis is performed to select the most appropriate actuator for producing the required torque to manipulate the fingers effectively. The kinematics of the index finger while performing a finger curl exercise is obtained. The proposed linkage mechanism can drive the index fingers of both hands. Simulation and experimental results proved the feasibility and effectiveness of the proposed design to be used for index finger rehabilitation for a wide range of users and applications by making simple minor alterations in the design. Also, a scheme for when the device can be used for rehabilitating the middle finger together with the index finger when performing flexion and extension motions is discussed.

Configuration Design and Kinematic Analysis of the Self-Alignment Type Finger Exoskeleton Mechanism

Design and Simulation Experiment of Rigid-Flexible Soft Humanoid Finger

Self-reconfiguration Method of an Intelligent Multi-mode Linkage Finger Based on Quantitative Reconstruction of Center Point

Mechanism Design and Performance Analysis of a Wearable Hand Rehabilitation Robot

A hand exoskeleton using a multi-segment mechanism with two degrees-of-freedom for each finger

Fusing Topology Optimization and Pseudo-Rigid-Body Method for the Development of a Finger Exoskeleton

Design of a Multi-Mode Mechanical Finger Based on Linkage and Tendon Fusion Transmission

Finger Exoskeleton for Rehabilitation of Finger Extension and Flexion by Multi-Segment Mechanism

Design and Characterization of a Rolling-Contact Involute Joint and Its Applications in Finger Exoskeletons

A Design of Hand Rehabilitation Exoskeleton Mechanism Adapted to Different Finger Lengths.

Design, Analysis, and Experiment of a Coupled-Adaptive Underactuated Prosthetic Handbased on Linkage Mechanisms

Design of an Underactuated Finger Based on a Novel Nine-Bar Mechanism

Design of A Hand Exoskeleton Rehabilitation Device

Optimal Design of a Bilateral Stand-Alone Robotic Motion-Assisted Finger Exoskeleton for Home Rehabilitation

Development and Validation of a Self-Aligning Knee Exoskeleton With Hip Rotation Capability

Design and Analysis of a Closed Link Mechanism of Dexterous Fingers

Developing of A Rigid-Compliant Finger Joint Exoskeleton Using Topology Optimization Method

Development of a Multi-DOF Anthropomorphic Prosthetic Hand

Finger-Individuating Exoskeleton System with Non-Contact Leader-Follower Control Strategy

Design of a wearable hand exoskeleton for exercising flexion/extension of the fingers

A Novel Robotic Exoskeleton for Finger Rehabilitation: Kinematics Analysis