Abstract:With the progress in modern high-energy physics, the Standard Model is constantly being refined. As the last brick of the Standard Model, the Higgs boson was confirmed to be discovered in the Large Hadron Collider (LHC) in 2012. For the further exploration of the Higgs boson, the Circular Electron Positron Collider (CEPC) is proposed. The baseline detector concept of CEPC is guided by the particle flow principle. The Particle Flow Algorithm (PFA) reconstructs a list of low-level particles and associates every detector hit with these particles. The high granularity hadronic calorimeter (HCAL) represents an essential component of PFA-based detectors. This paper mainly presents the single-layer electronics design and development for the scintillator analog hadronic calorimeter prototype (AHCAL). The single-layer readout electronics consists of front-end electronics board (FEB) and data interface (DIF) board. The FEB carries the silicon photomultipliers (SiPM), plastic scintillators, and the SiPM signal readout circuit. A single SiPM coupled with a scintillator constitute the basic detection unit. The size of scintillator used here is 4 cm x 4 cm. A sensitive area of 72 x 72 cm(2) can be covered by the design presented here. 324 SiPMs coupled with scintillators are mounted on each FEB. Besides the huge sensitive area, The AHCAL prototype must also meet strict requirements on the integration and robustness of the electronics. This paper develops a complete single-layer readout electronics design that meets the requirements for use in the AHCAL. The results of beam test shows that the peak of the minimum ionizing particle (MIP) is separated from the pedestal evidently and the signal-to-noise ratio (SNR) is better than 20. The volume required for the electronics is less than 4 cm3 per channel. In addition, the FEB is sufficiently robust to avoid damage during intercontinental transportation. The development of the single-layer electronics represents significant progress in the design of a prototype device that meets the requirement for use in the CEPC.

A Prototype of an ATCA-Based System for Readout Electronics in Particle and Nuclear Physics

Prototype Design of Readout Electronics for In-Beam TOF-PET of Heavy-Ion Cancer Therapy Device

An ATCA-based Prototype Data Readout System for Multi Wire Drift Chamber in Nuclear and Particle Physics Experiment

ATCA-based Computation Platform for Data Acquisition and Triggering in Particle Physics Experiments

A High-End Reconfigurable Computation Platform for Nuclear and Particle Physics Experiments

Application of ATCA in trigger and DAQ system for experimental physics

A 1024-Channel Wideband Digital Subsystem Prototype for Large Aperture Array Radio Telescope

The Prototype Design of Integrated Base for PMT with Pulse Digitalization and Readout Electronics

Hardware/software co-design of an ATCA-based computation platform for data acquisition and triggering

MicroTCA implementation of synchronous Ethernet-Based DAQ systems for large scale experiments

A multi-channel DAQ system based on FPGA for long-distance transmission in nuclear physics experiments

A Front-End Electronics Prototype Based on Gigabit Ethernet for the ATLAS Small-Strip Thin Gap Chamber

Prototype of a Readout Control ASIC for Data Collection and Command Distribution

Front - End Data Readout of High Density CBM - TOF Super Module

Back-end Electronics for Low Background and Medium Scale Physics Experiments Based on an Asymmetric Network

An SCA ASIC-based Multi-Channel Readout System for a Prototype Multi-Purpose TPC at CSNS Back-n White Neutron Source

Prototype for the trigger-less data acquisition of the P̅ANDA experiment 2014 IEEE real time conference

A Generic High Bandwidth Data Acquisition Card for Physics Experiments.

The Single-Layer Readout Electronics Design and Development for CEPC Scintillator Analog Hadronic Calorimeter Prototype

A Distributed Readout Network ASIC for High-Density Electrode Array Targeting at Neutrinoless Double-Beta Decay Search in a Time Projection Chamber

FPGA based High Speed Data Acquisition System for High Energy Physics Application