ICOPE-15-C088 Experimental research on simultaneous removal of CO_2, SO_2 and NOx by amine-sulphone solution

Lian LI,Hu Bin,Na LI,Qulan ZHOU,Yi Zhang,Jizhao SHEN
DOI: https://doi.org/10.1299/jsmeicope.2015.12._icope-15-_167
2015-01-01
The Proceedings of the International Conference on Power Engineering (ICOPE)
Abstract:Environmental problems caused by CO_2, SO_2, NO_x and other pollutants have become increasingly prominent. It has been a research hotspot to remove CO_2, SO_2 and NO_x simultaneously with simple technique, relative low operation cost. We made amine-sulphone solution with N-methyl-diethanolamine (MDEA) and dimethyl sulfoxide (DMSO) as the absorbent of SO_2/CO_2/NO_x. A bubbling bed absorption system was designed and built to investigate the absorption properties of amine-sulphone solution toSO2/CO_2/NO_x. The solution formula and working condition were discussed to figure out the optimum choices of formula, solution concentration and flow rate of flue gas. According to the regulations of absorption rate, absorptive amount and removal ratio, the solution formula with 52.5%MDEA+17.5%DMSO showed the best simultaneous absorption properties to SO_2/CO_2/NO_x. And 70% were the optimum concentration choice for the of amine-sulphone solution, taking absorbent cost, mass transfer and absorption quality into consideration. There's a flow rate inflexion point for the absorption of each gas, which is the boundary of rapid dropping and stable interval of removal ratio. The minimum of inflexion point for SO_2/CO_2/NO_x was the optimum flue gas flow rate for high removal ratio and low cost, which was 1L/min in the experiment.
What problem does this paper attempt to address?