Crystallization Behavior of Zr55al10ni5cu30 Amorphous Alloys with Different Morphologies and Thermal History Conditions
Hu Qiao,Lin Xin,Yang Gaolin,Huang Weidong,Li Jinfu
DOI: https://doi.org/10.3724/sp.j.1037.2012.00433
2012-01-01
Abstract:This work investigated the crystallization behavior of Zr55Al10Ni5Cu30 amorphous alloy (bulk and powder with different morphologies) under different heating and cooling rate conditions, and has found that the crystallization behavior of Zr55Al10Ni5Cu30 under different thermal history conditions was quite different. Under conventional heat treatment condition, the heating and cooling rates of the alloy were lower, the Zr55Al10Ni5Cu30 bulk amorphous alloy began to crystallization above the outset crystallization temperature T-x, the CuZr2 nanocrystalline was formed. With increasing temperature, its grain size became bigger, when exceeding the melting point, the thick CuZr2 lath+eutectic organizations of lath (CuZr2)+(Zr, Cu, Al, Ni) were formed under furnace cooling condition; under laser melting condition, however, the heating and cooling rates of alloy were higher, with increasing number of pulse frequency, the crystallization effect of Zr55Al10Ni5Cu30 bulk amorphous alloy accumulated gradually, in heat affected zone spherulites were precipitated and grew up, subsequently became unstable and finally a belt of equiax crystals were formed along the weld pool boundary. For amorphous alloy powder, due to its poorer the cooling performance than bulk amorphous, the cooling rate was lower, causing the powder particles crystallized into equiaxed dendrite during laser melting process, and with increasing laser energy, the equiaxed dendrite size increased.