Abstract:Magnetic refrigeration (MR) has the characteristics of green environmental protection, high energy efficiency and reliable operation, which is expected to replace gas compression refrigeration in the future. Based on the principle of MR, Baotou Research Institute of Rare Earths (BRIRE) successfully developed a practical room temperature magnetic refrigerator with two regenerators. The performance of the magnetic refrigerator in different environments was studied, and the velocity distribution of the fluid in regenerator together with the temperature span between the cold end and hot end were analyzed by numerical calculation. The magnetic refrigerator is mainly composed of a refrigeration chamber, two regenerators, magnetic field system, valves, a pump and so on. The magnetic field system consists of two sets of double-layer annularly nested NdFeB permanent magnetic arrays, which can accommodate two regenerators. The magnetization and demagnetization of magnetic refrigerant are realized by the rotation of the inner magnetic array, and the range of generated magnetic field is 0-1.4 T. The magnetic refrigerator adopts 2 kg spherical Gd particles as magnetic refrigerant and water as heat exchange fluid, and the cycle frequency is 0.25 Hz. When the cold end is equipped with a 117 L refrigeration chamber at ambient temperature of 22 °C, the temperature of refrigeration chamber can reach 8 °C, and the refrigeration temperature span is 26 °C, which meets the requirement of the market for refrigeration. The maximum cooling power of the magnetic refrigerator measured by compensation method is 100 W. The simulation results of the temperature of flow and cold end are in good agreement with the experimental results.

Performance Characteristics of a Magnetic Ericsson Refrigeration Cycle Using La(Fe0.88Si0.12)13H1 or Gd As the Working Substance

Performance optimization on the irreversible regenerative Ericsson refrigeration cycle using electrocaloric materials as the working medium

Development And Analysis Of A 4.2k G-M Refrigerator

Theoretical Investigation on the Performance of a Modified Refrigeration Cycle Using Binary Zeotropic Hydrocarbon Mixture R170/R290

Large Magnetic Entropy Change Above 300 K In A 14 La0.7ca0.2sr0.1mno3 Single Crystal

The effect of thermal hysteresis on the performance of a regenerative Ericsson refrigeration cycle with MnFe-based composite material

A numerical comparison of Gd, Pr0.65Sr0.35MnO3 and single LaFeCoSi for use in a magnetic refrigeration.

Broad table-like magnetocaloric effect in GdFeCo thin-films for room temperature Ericsson-cycle magnetic refrigeration

Thermodynamic modeling, material selection, and new dimensioning of a multilayer regenerator for a magnetic refrigeration system

Magnetocaloric Effect with Low Magnetic Hysteresis Loss in Ferromagnetic Ni-Mn-Sb-Si Alloys

Comparative Study on the Energy Performance of Two Different Absorption-Compression Refrigeration Cycles Driven by Low-Grade Heat

Large Magnetocaloric Effect with a Wide Temperature Range in Gd5Si4

Magnetic properties and promising magnetocaloric performances in the antiferromagnetic GdFe2Si2 compound

Refrigeration performance enhancement of pulse tube refrigerators with He–H2 mixtures and Er3NiHx regenerative material

Performance study of a double-regenerator room temperature magnetic refrigerator with 26 °C temperature span

Magnetic refrigeration: a promising new technology for energy saving

Thermomagnetic Generation Performance of Gd and La(Fe, Si) 13 H y /In Material for Low‐Grade Waste Heat Recovery

Study of magnetic entropy changes in Gd1-xTx(T = Ti, Cr, Fe and Cu) alloys

Magnetocaloric effect in high Gd content Gd-Fe-Al based amorphous/nanocrystalline systems with enhanced Curie temperature and refrigeration capacity

Numerical simulation of a low temperature hybrid refrigerator combining GM gas expansion refrigeration with magnetic refrigeration

The Effect of Fe Addition on the Curie Temperature and Magnetic Entropy of the Gd45Co50Al5 Amorphous Alloy