Abstract:Elastocaloric (eC) cooling using shape memory alloy (SMA) with zero direct carbon emission is a promising alternative of traditional vapor-compression technology. Compressive eC refrigeration prototype (ERP) performs high fatigue life but suffers from the limited cooling performance. Many studies focus on enhancing the heat transfer property of compressive eC regenerators to improve the specific cooling power ( SCP ). However, reducing the SCP loss is also essential for developing high-cooling-performance compressive ERPs but has not been given sufficient attention. In this study, we revealed that the force holder widely used in compressive ERPs works as an inactive section that dramatically reduce the SCP produced by the NiTi SMA active section. Numerical heat transfer simulations and experiments were conducted to study the impact of the inactive section on the SCP at varied operation parameters. Nondimensionalized governing equations of the numerical model revealed that the volume ratio ( Vol non ) of the fluid channel of the inactive section to that of the active section is the determinant geometric parameter for the SCP decrease. Numerical results show that, larger operation frequency f ERP , smaller dimensionless fluid velocity V * and system temperature span (∆ T span ) lead to more pronounced decreases in SCP non (ratio of the SCP to ideal SCP ideal at Vol non = 0) as the Vol non increases. It also indicates that the Vol non should be minimized to better < 0.08 for achieving excellent SCP non > 0.95. Experiments validate that the regenerator with a reduced Vol non = 0.08 exhibits a notable increase of 30.8% and 66.7% in zero-∆ T span SCP and no-load ∆ T span respectively, in comparison to the regenerator with Vol non = 0.5. Therefore, minimizing the Vol non of the inactive section via reducing the length and diameter of the fluid channel inside the force holder is necessary and highly recommended for developing high-performance compressive ERPs.

Performance optimization on the irreversible regenerative Ericsson refrigeration cycle using electrocaloric materials as the working medium

Ecological Optimization for an Irreversible Magnetic Ericsson Refrigeration Cycle

Performance evaluation and energy-saving potential comparison of a heat-powered novel compression-enhanced ejector refrigeration cycle with an economizer

Performance Evaluation of a Modified Refrigeration Cycle with Parallel Compression for Refrigerator-Freezer Applications

Performance Evaluation of an Ejector Subcooling Refrigeration Cycle with Zeotropic Mixture R290/R170 for Low-Temperature Freezer Applications

Performance Study of an Enhanced Ejector Refrigeration Cycle with Flash Tank Economizer for Low-Grade Heat Utilization

Performance Analysis of an Advanced Ejector-Expansion Autocascade Refrigeration Cycle

Theoretical Investigation on the Performance of a Modified Refrigeration Cycle Using Binary Zeotropic Hydrocarbon Mixture R170/R290

Comparative Study on the Energy Performance of Two Different Absorption-Compression Refrigeration Cycles Driven by Low-Grade Heat

Concept Design And Numerical Evaluation Of A Highly Efficient Rotary Electrocaloric Refrigeration Device

Comparative Study on Two Low-Grade Heat Driven Absorption-Compression Refrigeration Cycles Based on Energy, Exergy, Economic and Environmental (4E) Analyses

Research On Performance Of Regenerative Room Temperature Magnetic Refrigeration Cycle

Numerical Evaluation of a Kilowatt-Level Rotary Electrocaloric Refrigeration System

Discussion on refrigeration cycle for regenerative cryocoolers

Numerical Modeling of an Active Elastocaloric Regenerator Refrigerator with Phase Transformation Kinetics and the Matching Principle for Materials Selection

An Electrocaloric Refrigerator Without External Regenerator

Performance Optimization of an Irreversible Carnot Refrigerator with Finite Mass Flow Rate

An Electrocaloric Refrigerator with Direct Solid to Solid Regeneration

The effect of thermal hysteresis on the performance of a regenerative Ericsson refrigeration cycle with MnFe-based composite material

Efficient ecological function analysis and multi-objective optimizations for an endoreversible simple air refrigerator cycle

Effect of inactive section on cooling performance of compressive elastocaloric refrigeration prototype