Abstract:In Section 2.3, paragraph 2, the first sentence should read: “Comparing the results (Figure 5), the membranes all has a qmax value of near 2.25 nm−1.” The qmax value is 2.25 nm−1 rather than 3.25 nm−1. SAXS profiles of PVDF/PEO/DBS-H membranes at room temperature. In the Experimental Section, paragraph 3, the fifth sentence should read: “The scattering patterns were integrated to generate an I vs q curve, where I is the intensity of scattered X-rays and q is the scattering vector r, q is calculated from scattering angle θ and the wavelength of the X-ray beam λ by the equation q= 4πsin (θ)/λ.” The remaining two sentences of that paragraph should be disregarded. Figure 5 in the original manuscript should be replaced by the new version of Figure 5 shown below. Figure 5 in the published article is the relation between scattering intensity and the scattering angle, rather than q [calculated as q=4πsin (θ)/λ], due to an oversight by the author. The caption remains the same and is included for completeness. The author apologises for these oversights.

Erratum to: Swimming Behavior Analysis Based on Bacterial Chemotaxis in Solution

Corrigendum for “A Novel Kinase Subverts Aluminium Resistance by Boosting Ornithine Decarboxylase‐dependent Putrescine Biosynthesis”

Correction to: Rational design of engineered microbial cell surface multi-enzyme co-display system for sustainable NADH regeneration from low-cost biomass

Corrections to “zinc Oxide Nanostructures and High Electron Mobility Nanocomposite Thin Film Transistors” [nov 08 3001-3011

Correction: Corrigendum: Autophagy-associated alpha-arrestin signaling is required for conidiogenous cell development in Magnaporthe oryzae

Corrigendum: New Anhydrous Proton Exchange Membrane for Intermediate Temperature Proton Exchange Membrane Fuel Cells

Erratum to “critical Influence of Carbon Nitride Self-assembly Coating on the Electrochemical Performance of SnO2-TiO2 Nanocomposite Anode Material for Lithium Ion Battery[Int. J. Electrochem. Sci., 11 (2016) 2461-2472]”

Erratum: Evaluation of Heat Generation and Thermal Degradation of Lithium Ion Batteries by a Calorimetry Method [ J. Electrochem. Soc., 168, 060553 (2021)]

Correction: Corrigendum: Manipulating Surface Reactions in Lithium–sulphur Batteries Using Hybrid Anode Structures

Erratum: Elementary Reaction Kinetic Model of An Anode-supported Syngas Fueled Solid Oxide Fuel Cell Considering The Carbon Deposition Effect [ECS Trans. 103 (1) 949-957 (2021)]

Erratum: Good Structural Stability of Si Anodes Achieved through Dispersant Addition and Use of Carbon Fabric as Conductive Framework [ J. Electrochem. Soc., 168, 060517 (2021)]

Erratum to: Isolated atomic catalysts encapsulated in MOF for ultrafast water pollutant treatment

Author Correction to “mesoscale Simulation of Vesiculation of Lipid Droplets”

Correction To: High-throughput Profiling of Microbial Community Structures in an ANAMMOX-UASB Reactor Treating High-Strength Wastewater.

Correction to: Continuous-Flow Microreactors for Polymer Synthesis: Engineering Principles and Applications

Correction to: Distribution characteristics and removal rate of antibiotics and antibiotic resistance genes in different treatment processes of two drinking water plants

Corrigendum: A Nickel‐ and Cerium‐Doped Zeolite Composite: an Affordable Cathode Material for Biohydrogen Production in Microbial Electrolysis Cells

Correction: Model of protocell compartments – dodecyl hydrogen sulfate vesicles

Correction to “Direct and Indirect Electrochemical Degradation of Acid Blue 111 Using IrOx Anode” [Int. J. Electrochem. Sci., 12(2017)8564-8577; doi: 10.20964/2017.09.44]

Errata to "Benchmarking Power Generation From Multiple Wastewater Electrolytes in Microbial Fuel Cells With 3D Printed Disk-Electrodes"

Correction: Corrigendum: Full 180° Magnetization Reversal with Electric Fields