Abstract:Casing damage is a common problem encountered during oil and gas field development due to the complex stress state of the casing. Despite the large number of studies focusing on this problem, the mechanism of non-uniform in-situ stress-induced casing damage in a low-permeability reservoir is still unclear. In this study, casing damage due to non-uniform in-situ stress variations was investigated, and then the tectonic stress coefficients in the study area were determined by an in-situ stress inversion technique, which led to the derivation of formulas for calculating the maximum and minimum horizontal in-situ stresses. Subsequently, finite element numerical simulations were performed to assess the stress distribution during the formation of the casing cement sheath in a G155 block, a typical low-permeability reservoir. The results indicate that casing damage is caused not only by non-uniform in-situ stresses but also by various additional creep-induced loads. Subsequent finite element investigations into casing behavior under mudstone creep conditions indicated that immersion of mudstone in water instigated further shearing and deformation of the casing, culminating in premature well failure prior to water inundation. Notably, Von Mises stress levels exhibited a positive correlation with injection production ratios, with values exceeding critical thresholds leading to distinct modes of mechanical failure including shear-induced deformations, longitudinal tensile stress, and localized yielding near water wells. Maintenance of an optimal injection production ratio is identified as a key strategy for prolonging casing longevity in the region. To this end, recommendations include augmenting the casing wall thickness or enhancing the steel pressure specifications to mitigate casing damage progression, thereby extending the operational lifespan. This research serves as a pivotal theoretical framework for informing future development strategies aimed at mitigating and preempting casing failures in a low-permeability reservoir.

The Oil Well Casing's Anticorrosion and Control Technology of Changqing Oil Field

Inner Corrosion Mechanism of Casing and Its Control Technology in Zhongyuan Oilfield

Corrosion Status of Oil Well Pipe and Anti-corrosion Technology Development

Corrosion Resistance of Vacuum Gas Nitriding Well Casing in Changqing Oilfield

Study and Application of the Corrosion Inhibitor for Completion Fluid in a Gas Field of Changqing Oilfield

Development and Application of Integrated Management System for Casing Damage Well

A new technology combined corrosion inhibition and water shutoff in oil well

Research on Oil and Gas Field CO_2 Corrosion Protection Technology

Study on Performances of YG Series of Anti-Corrosive Coatings for Oil Tube

Study of Separate Layer Fracturing Techniques on Casing Damaged Wells

Composite Plugging Removal Technology and Application in Low Permeability Oilfield

TRAIL STUDY OF WATER TEST AND CASING CORROSION ENGINEERING OF SU-11 WELL IN CHANGQING GAS FIELD

ANTI-CORROSION TECHNOLOGIES FOR TUBINGS IN OIL AND GAS WELLS

Application of Acidizing and Plugging Removal Technology in Chang 2 Reservoir of CH Oilfield

Design,Development and Application of TP140V Extra-high Strength Oil Casing for Extra-deep Complex Well Service

The Development and Field Application of Key Materials for Coupling Profile Control of Injection Well

Application of Composite Spraying Technique for Double Metal in Serious Corrosion Gas Wells

Study of the Corrosion and Protection Technology of Oil and Gas Pipeline

Research on Mechanism of Non-Uniform In-Situ Stress Induced Casing Damage Based on Finite Element Analysis

Development of Double Layer Metal Thermal Spray: Novel External Corrosion Mitigation Method for Gas Well Tubing

Research and Application of Online Electromagnetic Wax Prevention Device for Oil Wells