Abstract:In this letter, a novel high step-up dc-dc converter with an active coupled-inductor network is presented for a sustainable energy system. The proposed converter contains two coupled inductors which can be integrated into one magnetic core and two switches. The primary sides of coupled inductors are charged in parallel by the input source, and both the coupled inductors are discharged in series with the input source to achieve the high step-up voltage gain with appropriate duty ratio, respectively. In addition, the passive lossless clamped circuit not only recycles leakage energies of the coupled inductor to improve efficiency but also alleviates large voltage spike to limit the voltage stresses of the main switches. The reverse-recovery problem of the output diode is also alleviated by the leakage inductor and the lower part count is needed; therefore, the power conversion efficiency can be further upgraded. This letter shows the key waveforms of the proposed converter and the detailed derivation of the steady-state operation principle. The voltage conversion ratio, the effect of the leakage inductance and the parasitic parameters on the voltage gain are discussed. The voltage stress and current stress on the power devices are illustrated and the comparisons between the proposed converter and other converters are given. Finally, a prototype circuit rated 200-W output power is implemented in the laboratory, and the experimental results show the satisfactory agreement with the theoretical analysis.

A New Push-Pull DC/DC Converter Topology with Complementary Active Clamped.

Improved High Step-Up Dc-Dc Converter Based on Active Clamp Coupled Inductor with Voltage Double Cells

Soft switching characteristics of a novel and efficient DC/DC converter

Study of Interleave DC/DC Converter in Energy Feedback Electronic Power Load

Designing and Analysis of an Interleaved Boost Converter with Passive Lossless Clamp Circuits

Simple Topologies of PWM AC-AC Converters

Novel High Step-Up DC–DC Converter with an Active Coupled-Inductor Network for a Sustainable Energy System

An Active-Clamping Current-Fed Push-Pull Converter For Vehicle Inverter Application And Resonance Analysis

A New Interleaved Active-Clamp Forward Converter with Parallel Input and Series-Parallel Output

A Modified Y-Source DC–DC Converter with High Voltage-Gains and Low Switch Stresses

High Step-Up/Down Switched-Capacitor Based Bidirectional DC-DC Converter

Design of Single Ended Output DC-DC Convertor with Active Clamp Forward Topology

A New Five-Level Hybrid-Clamped Converter with Reduced Number of Clamping Devices

A Novel Single-Stage Five-Level Common-Ground-Boost-Type Active Neutral-Point-Clamped (5L-CGBT-ANPC) Inverter

A Novel Hybrid-Clamped Four-Level Converter

A NOVEL ACTIVE CLAMPING BOOST CONVERTER

A High Gain Quasi Single Stage LLC Resonant DC/DC Converter with Coupled Inductor and Partial Active Clamp

A Multilevel Topology by Combination of Switched-capacitor and Diode-clamped Circuits

An Interleaved Winding-Coupled Boost Converter with Passive Lossless Clamp Circuits

ZVS Active-Clamped Compensative Reset Dual-Switch Forward Converter

Study of a High Step-Up Voltage Gain DC/DC Converter with Passive Lossless Clamp Circuit