Abstract:Abstract Currently, many different aircraft engine types exist. They have a wide range of operating conditions: the flight speed can vary from zero to hypersonic values, the flight altitude from near-earth conditions to space flights. During the flight, loads are not kept constant. Engines have significant dynamic overloads, temperature and pressure differences, can operate in conditions of high humidity or dust, as well as in various aggressive environments. The development of aviation and rocket engine building is associated with a continuous increase in the working thermodynamical cycle parameters. Further improvement of gas turbine engines (GTE) can be carried out in two directions. The first is using new advanced engine designs based on a modernized cycle, with a different fuel, original design, and power scheme. This direction also includes the application of new high-performance elements in the engine: bearings, seals, coatings, etc. The second direction is related to the improvement of existing structures, increasing their efficiency by more detailed working conditions forecasting based on the use of modern computing software systems. This article presents a study of the potential mechanical face gas dynamic seal (FGDS) in the support in an aircraft engine compressor. Aircraft engines are characterized by multi-mode operation and high temperature levels in the internal cavities. For a FGDS operating with a working gap of several microns the exact determination of the deformation value is a very important result of the design process. This article considers the influence of the convective heat transfer coefficients distribution on the value of sealing rings thermal deformations. To achieve this goal, two compaction models were created: the gas-dynamic model for determining the convective heat transfer coefficients in the ANSYS CFX software program; and the structural model for calculating the resulting deformations. Interaction between the models was performed based on a specially created methodology. The obtained results can be used in the design of a FGDS for the supports in the compressors of aircraft engines and power plants.

Inspection of Press Joints Based on the Analysis of Their Deformation Patterns under Local Thermal Loading

Analytical and Experimental Method of Thermal Load Estimation for Seals in Transmission of Vehicle

Thermo-Mechanical Coupling Analysis of the Actuating Mechanism in a High Speed Press

Residual stress and deformation analysis on thermal shrink-fitted joint in the semi built-up marine crankshaft

Coupled Thermomechanical Response Measurement of Deformation of Nickel-Based Superalloys Using Full-Field Digital Image Correlation and Infrared Thermography

ВПЛИВ УМОВ РОБОТИ НА ТЕМПЕРАТУРНИЙ РЕЖИМ ПІДШИПНИКІВ З МЕТАЛЕВИМИ ТА КЕРАМІЧНИМИ КУЛЬКАМИ

Three-component strain gauge for precise measurement of load fluctuations

Hypothesis of the nature of cross-sectional shape distortion of the cold-pilgering mill die groove during dry pipe rolling

Combined Thermal and Wear Analysis of Linear Rolling Guide Subjected to Rigid–Flexible Coupling Motion Stage

Thermal-structure interactions on the nonlinear behavior of the heavy-load mechanical press with multiple clearance-induced joints

Deformation Measurement Based on Digital Image Correlation and Finite Element Analysis Based on Cooling Method of Heavy Hydraulic Press Frame

Development of Double-Insulated Ring Sensors for Hollow Pin Preload Measurement

Research on the Mechanical Properties and Temperature Compensation of an Intelligent Pot Bearing for a Pipe-Type Welding Strain Gauge

New Method for Precise Measurement of Clamping Plate Deformations on Forming Presses

Evaluation of the Thermal Expansion Effect of the Carbon–Carbon Composite Surface on Contact Interaction with a Ring-Shaped Sample

INFLUENCE OF THE SEALING ON APPEARANCE AND TRANSMISSION OF TEMPERATURE DEFORMATIONS IN ELECTRONIC MODULES

The influence of nonuniform heat transfer coefficient distribution on the value of thermal deformations in mechanical gas dynamic seal rings

Design and Analysis of a Self-Lubricating Nuclear Joint Bearing above 320°C

Detection of Elastic Deformation in Metal Materials in Infrared Spectral Range

Investigation of local hot spots in sealing rings with different sealing materials

Study of self-heating and local strain rate in polyamide-6 and short fibre glass/polyamide-6 under tension through synchronised full-field strain and temperature measurements