Abstract:Different modes of degradation and aging processes that result in either chemical or morphological alteration in the polymer electrolyte membranes (PEM) during the course of fuel cell operation are of paramount importance of commercial acceptance. The effect of radicals on the PEM durability is of particular interest since a common feature of many hydrocarbon-based membranes is that the building block consists of sulfonic acid substituted aromatic rings, which are much more sensitive to radical attack than the Teflon-like backbone in perfluorinated sulfonic acid type materials. In this work, we attempt to provide answers to the hydroxyl radical initiated durability issues at the polymer electrolyte-electrode interface by analyzing the performance of some novel non-fluorinated membranes using a newly designed durability evaluation method which enables analysis under fuel cell-operating conditions. This method is able to separate the membrane evaluation process into cathode and anode half cell processes for individual analysis of their respective interfacial degradation passed through the catalyzed working electrodes and reference electrodes side of the MEA, and humidified oxygen was passed through the non-catalyzed counter electrode side. After full humidification of the MEA, the working electrodes were either held at the typical anode operating potential of PEMFC (0.1-0.2 V, vs. RHE) or left in open circuit potential condition for varied periods of time. After the test, membrane at the interface with the working electrodes was subjected to mortem analysis. The results were then compared with corresponding properties of the membrane before the test. the electrodes to the polymer membrane.Characterization Techniques. After the durability experiment, the MEA was uninstalled from the cell, and the working electrodes were carefully peeled away from the MEA. Anhydrous ethanol was used to facilitate the peeling process. The membrane samples with a size of 1cm x 5 cm were then washed thoroughly with deionized water before post mortem analysis. All FT-IR (ATR) spectra were collected from 64 scans at 4cm'1 resolution. Dry nitrogen gas was purged around the sample during the measurement to eliminate moisture in the air. Proton conductivities vere determined from the water vapor equilibrated membrane samples at 30°C using a four-probe conductivity cell setup described in our prior publication?15i. Intrinsic viscosity was chosen as a qualitative parameter reflective of changes in molecular weight of the membranes. The polymer solution was measured according to the single point method developed by Solomon and Ciuta[16] with an Ubbelohde viscometer in a 25°C water bath, using 1% lithium bromide inN-methylpyrrolidone (l%LiBr/NMP) as the solvent.

The Degradation Effect on Proton Dissociation and Transfer in Perfluorosulfonic Acid Membranes.

A Kinetic Model for the Chemical Degradation of Perfluorinated Sulfonic Acid Ionomers: Weak End Groups Versus Side Chain Cleavage

Aspects of the Chemical Degradation of Pfsa Ionomers Used in Pem Fuel Cells

Evaluation of Proton Transport and Solvation Effect in Hydrated Nafion Membrane with Degradation.

Degradation Mechanism of Polystyrene Sulfonic Acid Membrane and Application of Its Composite Membranes in Fuel Cells

XPS Analysis of Polymer Membrane Degradation in PEMFCs

Degradation Behaviors Of Perfluorosulfonic Acid Polymer Electrolyte Membranes For Polymer Electrolyte Membrane Fuel Cells Under Varied Acceleration Conditions

Degradation Differences of a Single Proton Exchange Membrane Fuel Cell: Energy Management Strategy and Dynamic Programming

Primary Study on Degradation Mechanism of Polystyrenesulfonic Acid Membrane and Its Composite Membrane in Fuel Cells

Modeling and Simulation of the Degradation of Perfluorinated Ion-Exchange Membranes in PEM Fuel Cells

Hydrophobic Modification of Flow Channel Surface and Its Effect on the Performance of Proton Exchange Membrane Fuel Cell

Mitigation of chemical degradation in perfluorosulfonic acid proton exchange membrane using regenerable hindered amine functionalized carbon quantum dots

Role of H3O· Radical in the Degradation of Fuel Cell Proton-Exchange Membranes

Ex Situ Investigation of the Proton Exchange Membrane Chemical Decomposition

Oxidative Degradation of Acid Doped Polybenzimidazole Membranes and Fuel Cell Durability in the Presence of Ferrous Ions

Ion-Exchange Strategy Enabling Direct Reformation of Unreliable Perfluorinated Cationic Polymer for Robust Proton Exchange Membrane towards Hydrogen Fuel Cells

Embrittlement Induced Fracture Behavior and Mechanisms of Perfluorosulfonic-Acid Membranes after Chemical Degradation

Perfluorosulfonic acid proton exchange membrane with double proton site side chain for high-performance fuel cells at low humidity

Sulfonated Poly(phenylene Sulfide) Grafted Polysulfone Proton Exchange Membrane with Improved Stability

Durability Issues at the Polymer Electrolyte Membrane and the Electrocatalyst Interface with Non-Fluorinated Ionomers

A Review of Proton Exchange Membrane Degradation Pathways, Mechanisms, and Mitigation Strategies in a Fuel Cell