Abstract:A low-power 23–25.5-GHz frequency-modulated continuous wave (FMCW) radar transceiver, implemented in 65-nm CMOS, is proposed for artificial intelligence-Internet of Things (AIOT) applications in this article. The transceiver integrates a frequency synthesizer, a power amplifier (PA), a low noise amplifier (LNA), I/Q mixers, a quadrature all-pass filter (QAF)-based local oscillator (LO) generator, and an analog baseband (ABB). A current-sharing LNA using -boosting three-turn coupling transformers and an LO generator using injection locking technique are employed to render high gain with low power consumption. Furthermore, a Class-B mixer with bulk injection (BI) technique is proposed to alleviate LO signal strength requirement with low power while enhancing conversion gain (CG) and linearity. Measurements demonstrate that the transceiver demonstrates a peak transmitter (TX) output power of 12.6 dBm with 28.5% efficiency, a receiver (RX) CG of 54.2 dB, a minimum RX NFdsb of 5.7 dB @ 1.6-MHz offset, an RX IIP3 of −24 dBm and an RX IP1dB of −34.5 dBm @42-dB gain across 23–25.5 GHz from a 1-V supply. To further reduce power consumption, the transceiver can work under a low supply voltage of 0.75 V and can still deliver a 9.1-dBm TX output power with 19.2% efficiency, a 49.6-dB RX CG, a 7.9-dB RX NFdsb @1.6-MHz offset, a −29.1-dBm RX IIP3, and a −41.7-dBm RX IP1dB @ 42-dB gain across 23.2–24.8 GHz. The measured phase noise is −102 dBc/Hz at 1-MHz offset at 23.4 GHz. The root-mean-square (rms) frequency error is 120 kHz (0.12%) for a sawtooth chirp with 100-MHz bandwidth and 1-MHz/s chirp-rate. With two external 20-dBi horn antennas, the radar demonstrates a 15.6-cm range resolution with 960-MHz modulation bandwidth in 20-m indoor tests. The entire transceiver occupies a chip area of mm2 including pads and consumes 155.9 mW from a 1-V supply, and a 103.6 mW from a 0.75-V supply.

A Compact 76-81 GHz Transceiver Front-End for Automotive Radar in 40-Nm CMOS

A 54-67-ghz Low-Power Highly-Integrated Transceiver in 65-Nm CMOS for FMCW Radar Applications

A 90-98-ghz FMCW Radar Transceiver Supporting Broadband Modulation in 65nm CMOS

A 56 – 65 GHz Highly-Integrated FMCW Radar Transceiver with 7.8 Db NF and 8 GHz Chirp-Bandwidth in 65-Nm CMOS

A CMOS Low Power K-band FMCW Radar Transceiver Front-End for AIOT Application

A 76-81Ghz FMCW Transceiver with 3-Transmit, 4-Receive Paths and 15dbm Output Power for Automotive Radars

A 76-81Ghz High-linearity CMOS Receiver Front-end for Automotive Radar

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

A Compact 76-81 GHz 3TX/4RX Transceiver for FMCW Radar Applications in 65-Nm CMOS Technology

A Fully-Integrated 77-GHz FMCW Radar Transceiver in 65-nm CMOS Technology

A 76–81-Ghz Four-Channel Digitally Controlled CMOS Receiver for Automotive Radars

A 77 GHz Frequency Doubling Two-Path Phased-Array FMCW Transceiver for Automotive Radar.

A Digitally Controlled CMOS Receiver with −14 Dbm P1dB for 77 GHz Automotive Radar

A Low-Power 23–25.5-GHz FMCW Radar Transceiver in 65-nm CMOS for AIOT Applications

A 77 GHz FMCW radar transmitter with reconfigurable power amplifier in 65 nm CMOS.

A 94ghz 2×2 Phased-Array FMCW Imaging Radar Transceiver with 11dbm Output Power and 10.5db NF in 65nm CMOS

A 75-90Ghz Driver Amplifier with High Out-Band Suppression for Automotive Radar in 65nm CMOS

A 90‐ to 115‐ghz Superheterodyne Receiver Front‐end for W‐band Imaging System in 28‐nm Complementary Metal‐oxide‐semiconductor

A 35-Ghz TX and RX CMOS Front-Ends for Ka-Band FMCW Phased-Array Radar Transceivers

A 76-81 GHz 2 x 8 MIMO Radar Transceiver With Broadband Fast Chirp Generation and 16-Antenna-in-Package Virtual Array

A CMOS 76-81 GHz 2TX 3RX FMCW Radar Transceiver Based on Mixed-Mode PLL Chirp Generator