Nanoimprint system alignment and overlay improvement for high volume semiconductor manufacturing
Yukio Takabayashi,Takehiko Iwanaga,Mitsuru Hiura,Hiroshi Morohoshi,Tatsuya Hayashi,Takamitsu Komaki
DOI: https://doi.org/10.1117/12.2514924
2019-03-26
Abstract:Imprint lithography is an effective and well known technique for replication of nano-scale features. Nanoimprint lithography (NIL) manufacturing equipment utilizes a patterning technology that involves the field-by-field deposition and exposure of a low viscosity resist deposited by jetting technology onto the substrate. The patterned mask is lowered into the fluid which then quickly flows into the relief patterns in the mask by capillary action. Following this filling step, the resist is crosslinked under UV radiation, and then the mask is removed, leaving a patterned resist on the substrate. The technology faithfully reproduces patterns with a higher resolution and greater uniformity compared to those produced by photolithography equipment. Additionally, as this technology does not require an array of widediameter lenses and the expensive light sources necessary for advanced photolithography equipment, NIL equipment achieves a simpler, more compact design, allowing for multiple units to be clustered together for increased productivity. Previous studies have demonstrated NIL resolution better than 10nm, making the technology suitable for the printing of several generations of critical memory levels with a single mask. In addition, resist is applied only where necessary, thereby eliminating material waste. Given that there are no complicated optics in the imprint system, the reduction in the cost of the tool, when combined with simple single level processing and zero waste leads to a cost model that is very compelling for semiconductor memory applications. Any new lithographic technology to be introduced into manufacturing must deliver either a performance advantage or a cost advantage. Key technical attributes include alignment, overlay and throughput. In previous papers, overlay and throughput results have been reported on test wafers. In this work, improvements to the alignment system, together with the High Order Distortion Correction (HODC) system have enabled better distortion and overlay results on both test wafers and device wafers. On test wafers, XMMO of 2.9nm and 3.2nm in x and y respectively was demonstrated. SMO of 2.2nm and 2.4nm was achieved, with an opportunity to further improve results by applying wafer chucks with better flatness specifications. Comparable results were also achieved on device wafers by applying a multi-wavelength alignment strategy and a feed forward strategy to realize align signal convergence within the allocated 0.60 second budget.