Abstract:A control strategy aimed at enhancing the voltage support capabilities of virtual synchronous generators during overvoltage scenarios was proposed. This method augments the reactive power absorption capacity of VSG, thereby suppressing transient overvoltage. As the application of renewable energy sources continues to increase, the virtual synchronous generator (VSG) has been proposed and received widespread attention. In China, new energy stations are typically situated at the transmission end of LCC‐HVDC lines. A failure in DC commutation can lead to overvoltage at the DC transmission end, thus posing a significant risk of disconnection from the grid due to the occurrence of overvoltage. Compared to when low‐voltage occur, it was discovered that, during overvoltage, VSGs face difficulties in rapidly attaining the preset power and transient instability. These issues can significantly impact the voltage support capability of the VSG. To address these concerns, an enhanced control strategy has been proposed. The control strategy sets reasonable power reference values, leveraging the advantage of fast voltage response in VSG by matching its voltage with virtual impedance. This ensures that the power rapidly reaches the designated reference value while reducing fluctuations in power angle. The transient power‐angle stability is validated using the energy function method. This approach enhances the reactive power absorbed by VSG, thereby mitigating transient overvoltage. Finally, simulation results from PSCAD/EMTDC validate the rationale and effectiveness of the control strategy.

Virtual Synchronous Generator Control in Solid-State Transformer with DC Voltage Compensation

Dual Synchronous Generator: A New Solution for Grid-Forming

Control Sheme of Novel Solid State Transformer Based on Virtual Synchronous Generator

Improved Power Decoupling Control Strategy Based on Virtual Synchronous Generator

A Virtual Synchronous Control for Voltage-Source Converters Utilizing Dynamics of DC-Link Capacitor to Realize Self-Synchronization

Research on Voltage and Power Balance Control for Cascaded Modular Solid-State Transformer

Synchronization Strategy for Virtual Synchronous Generator Based Energy Storage System

Improved VSG Control Strategy for Wind Turbines Connected to Non-Synchronized Grid under Commutation Failure

Comprehensive Control Strategy of Virtual Synchronous Generator under Unbalanced Voltage Conditions

A Control Approach of Novel Virtual Synchronous Generator and An Adaptive Control Strategy for Its Transient Process

Sub-synchronous oscillation suppression strategy for virtual synchronous generators based on dual-loop sliding mode control

Improved Virtual Synchronous Generator with Transient Damping Link and Its Seamless Transfer Control for Cascaded H-bridge Multilevel Converter-Based Energy Storage System

Control Strategy for Suppressing Power Oscillation of Virtual Synchronous Generator under Unbalanced Grid Voltage

An Enhanced Virtual Synchronous Generator Strategy for Suppressing Grid Voltage Sag

Comparisons of different control strategies for 20kVA solid state transformer

Using Virtual Synchronous Generator Control Based Energy Storage to Enhance the Stability of Sending Terminal in LCC-HVDC System

A Virtual Synchronous Generator Control Strategy for VSC-MTDC Systems

Virtual Synchronous Generator Strategy for VSC-MTDC and the Probabilistic Small Signal Stability Analysis

Virtual Synchronous Generator Control of VSC-HVDC System Based on MMC of Hybrid Topology

A Complex-Coefficient Voltage Control for Virtual Synchronous Generators for Dynamic Enhancement and Power-Voltage Decoupling

Overvoltage ride through control strategy for improving voltage support capability of virtual synchronous generator