Abstract:In the context of Oxy-fuel combustion, there is a strong industrial interest in highly fuel-rich flames, characterized by an equivalence ratio (Φ) exceeding 2.5, for the production of H 2 -CO-rich synthesis gas. The validation of existing chemical reaction mechanisms for this specific regime pose a significant challenge due to the scarcity of experimental data for this particular range of equivalence ratio. The scope of this study was therefore the determination of the laminar burning velocity s L of ultra-rich CH 4 -O 2 flames under varying conditions, such as high equivalence ratios and preheating temperatures using the heat flux burner method. The laminar burning velocity was determined for equivalence ratio within the range of 2.3 < Φ < 3.6 and preheating temperature ranging from 300 K to 455 K. Additionally, the impact of the of reducing the oxygen content in the oxidizer on s L was investigated by argon addition in molar percentages ranging from 40 % to 100 %. The results of our study reveal laminar burning velocities ranging from 5 cm/s to 45 cm/s for pure oxy-fuel CH 4 flames. Preheating is shown to increase s L and this effect can be represented by a power law correlation s L = s L,0 (T/T 0 ) α with α = 1.53. Furthermore, the dilution of the oxidizer with argon leads to a significant decrease in s L of approximately 50 % compared to pure oxy-fuel flames. It is worth noting that detailed reaction mechanisms in combination with molecular transport data are typically not validated within the selected equivalence ratio range. To assess the performance of such reaction schemes in predicting laminar burning velocity under the specified selected conditions, we evaluated 13 different reaction mechanisms sourced from the literature. We compared the laminar burning velocities obtained through calculations of laminar premixed 1D flames and, additionally compared these with experimental data. A sensitivity analysis of the laminar burning velocity were carried out for selected mechanisms. Among the mechanisms, the CalTech2.3 mechanism exhibited the most consistent and accurate performance, particularly at high equivalence ratios.

Laminar Flame Speed of Methane/Air at Engine-Relevant Conditions: Performance of Different Mechanisms

Laminar flame speeds of methane/air mixtures at engine conditions: Performance of different kinetic models and power-law correlations

Experimental Investigation of Lean Methane–Air Laminar Premixed Flames at Engine-Relevant Temperatures

Development and Verification of Simplified Methane/dimethyl Ether Mechanism for Micro-Combustion

Laminar Flame Speeds and Ignition Delay Times of Methane–air Mixtures at Elevated Temperatures and Pressures

Laminar flame speed measurement and combustion mechanism optimization of methanol–air mixtures

Laminar Flame Speeds of Lean High-Hydrogen Syngas at Normal and Elevated Pressures

Detailed Numerical Simulation of Transient Mixing and Combustion of Premixed Methane/air Mixtures in a Pre-Chamber/main-chamber System Relevant to Internal Combustion Engines

On kinetic mechanism for premixed laminar steady state methane-air flames

On Laminar Premixed Flame Propagating into Autoigniting Mixtures under Engine-Relevant Conditions

Laminar flame speeds of methane-air mixtures under reduced and elevated pressures

Comparative Research on Laminar Flame Propagation for Four C8 Fuels

Effects of radiation and compression on propagating spherical flames of methane/air mixtures near the lean flammability limit

Effects of Pressure Rise Rate on Laminar Flame Speed under Normal and Engine-Relevant Conditions

On the Determination of Laminar Flame Speed from Low-Pressure and Super-Adiabatic Propagating Spherical Flames

Experimental and numerical determination of laminar flame speeds of methane/(Ar, N2, CO2)-air mixtures as function of stoichiometry, pressure, and flame temperature

Experimental and numerical investigations of the laminar burning velocities of premixed fuel-rich methane oxy-fuel and oxygen-enhanced flames

On the accuracy of laminar flame speeds measured from outwardly propagating spherical flames: Methane/air at normal temperature and pressure

Characterization of Laminar Premixed Methanol–air Flames

On the Extraction of Laminar Flame Speed and Markstein Length from Outwardly Propagating Spherical Flames

Numerical investigation and prediction models for methanol-air laminar flame speed