Polarization Characteristics of the Mars’ InSight Seismic Data Based on the Horizontal to Vertical Spectral Ratio Curve

Wanbo Xiao,Yanbin Wang
2021-01-01
Abstract:Introduction: The InSight mission has returned high-quality seismic and meteorological data from Mars since the middle of February 2019 [1, 2]. It is the first time that a broadband seismometer was deployed on the surface of Mars and the 100-sps seismic data were obtained from Mars. Previous study has analyzed the polarized ambient noise on Mars’ surface below 1.0 Hz and revealed the environmental effects on seismic observation [3]. However, the polarization of the ambient noise in high frequencies remains to be discovered. In this study, we focus on the polarization characteristics of the ambient noise records on Mars’ surface for high frequency ranges. We first adopt the horizontal to vertical spectral ratio (HVSR) method to calculate the H/V curves of several continuous seismic data segments [3, 4]. Then the polarization characteristics of the particle motion are investigated in typical frequency bands of the H/V peaks using a polarization analysis method [5]. Data and Methods: The short period (SP) seismometer is more reliable in high frequencies. The SP data are sampled at an original sampling rate of 100 sps (sampling per second) on Mars while only part of the data can be returned to Earth due to the limitation of the data transferred. We thus choose several continuous 100-sps SP data segments whose observation time lengths exceed 20 hours for analysis. HVSR method. We adopt the classical singlestation HVSR method to obtain the H/V curves of the continuous Mars’ seismic data segments. The H/V curve is acquired by the taking ratio of the quadratic mean of the two horizontal spectrums to the vertical spectrum. In this study, Fast Fourier Transform is applied to data of 8192 points and the frequency resolution of the H/V curve is 0.0122 Hz. Polarization analysis method. The polarization analysis method first conduct eigen-analysis to the covariance matrix of three-component data, and then the planarity, rectilinearity, azimuth and the max/min incidences of particle motion can be extracted from the eigenvalues and eigenvectors. The data have be filtered to the interested frequency band before applying the polarization analysis. In this study, we choose several frequency bands, including the typical peak frequency bands of the H/V curve, for detailed analysis. HVSR curves: Figure 1 shows the statistical HVSR curves of the SP data in channel EHU/EHV/EHW recorded on sol 98-100, which exhibit multiple peaks both in relatively low frequency band (1-5 Hz) and higher frequency band (5-25 Hz). The H/V curves are generally steady despite a few high ratio values in low frequency (high period) band. The highest H/V peak at around 11.7 Hz is caused by lander vibrations and thus cannot be used for the inversion of subsurface layer [2, 6].
What problem does this paper attempt to address?