Abstract:The horizontal-to-vertical (H/V) method is a fundamental fast tool to estimate local site effect parameters by using the registered signals of the translational motion. The spectral ratio is mostly calculated using the Fourier Spectrum Analysis (FSA), which may lead to problems with accurate resonant frequency determination due to evident multi-amplification peaks occurrence on the spectrum. Alternatively the H/V ratio may be estimated by use Response Spectrum Analysis (RSA), where only a general amplification peak is expected. However, the fundamental limitations of the RSA assumption are related to the real impact of the events' scenario dependence (i.e., magnitude, distance, focal mechanism, etc.). The limitations and advantages of the RSA and FSA are commonly known in the case of the analysis performed for the translational signals. Therefore, the critical question is: should the RSA and FSA methods be used to estimate the H/V ratio of the recorded rotational signals of the events? The article presents horizontal-to-vertical (H/V) spectral ratios calculated for rotational and translational signals registered as an effect of mining-induced seismicity by four independent seismic stations located in Poland's Upper Silesian Coal basin. The spectral ratios of the signals were estimated using the RSA and the FSA method. The studies show that in the case of translational motion, the H/V estimations using the RSA derived clear information of the resonant frequency peak, confirming the method's usefulness in the case of multi-amplification peaks. The opposite situation was noticed in the case of the rotational motion. The derived H/V spectrum, using the RSA, produced single amplification peaks for the seismic stations, where the sensors were mounted on a small floor at a significant distance from the walls. In cases where the sensors were deployed on the building floor, a decrease in the reliability of the RSA and the FSA method was noticed. The results of the studies suggested that the possibility of the estimations of the H/V spectrum using the RSA and FSA algorithm is strongly limited for rotational motions due to the size of the floor and distance to the building walls where the sensors were mounted. The explanation of that fact is related to the effects of kinematic soil-structure interaction, which may significantly affect rotational measurements due to the tendency to obtain higher frequency content than in the case of the translations. Consequently, the values of the Z- component of the rotational motion may be lovered than in the free-field measurements, decreasing the reliability of the H/V estimations for rotational motion.

Polarization characteristics of Rayleigh waves to improve seismic site effects analysis by HVSR method

Estimation of Horizontal-to-vertical Spectral Ratios (ellipticity) of Rayleigh Waves from Multistation Active-Seismic Records

Near Surface Attenuation Compensation Using Downhole Seismic Data in the Qianjiang New Town Area in Urban Hangzhou

Improving Data Quality of Three-Component Measurements of Noise in Urban Environments Using Polarization Analysis

An Analytical Solution to the Scattering of Cylindrical SH Waves by a Partially Filled Semi-Circular Alluvial Valley: Near-Source Site Effects

Investigation and Use of Surface-wave Characteristics for Near-surface Applications

Improving Dispersion Measurement Using Weighted Stacking Based on Polarization Analysis

Numerical and Theoretical Investigation on the Origin of the Multiple Peaks of the H/V Ratio Curve

Improvement of Frequency–Bessel Phase-Velocity Spectra of Multicomponent Cross-Correlation Functions from Seismic Ambient Noise

Shallow Structure and Seismic Amplification Effects in the Weifang Segment of the Tanlu Fault Zone Based on the Spectral Ratio Method

Influence of Local Site Condition on Vertical-to-Horizontal Spectrum Ratio – Insight from Site Response Analysis

Techniques to identify microtremor wave contributions and impact to seismic site characterization

Modified Frequency–bessel Transform Method for Dispersion Imaging of Rayleigh Waves from Ambient Seismic Noise

Bandwidth-insensitive Extended Centroid Frequency Shift Method for Near-Surface Q Estimation

Application of horizontal-to-vertical spectral ratio on prospecting urbansite response and subsurface active faults in Mingguang, Anhui province

Comparing the low-frequency content of exploration seismic source - receiver combinations using surface waves: a field study in Hussar, Alberta

Surface Wave Dispersion Measurement with Polarization Analysis Using Multicomponent Seismic Noise Recorded by a 1-D Linear Array

Estimation of Near-Surface Shear-Wave Velocity by Joint Inversion of Dispersion and HVSR Curves of Rayleigh Waves from Multicomponent Active-Seismic Records

Estimation of the resonance frequency of rotational and translational signals evoked by mining-induced seismicity

Constraining the Depth Extent of Low-Velocity Zone along the Chenghai Fault by Dense Array Ambient Noise Interferometry and Horizontal-to-vertical Spectral Ratio

Determination of the V S profile at a "noisy" industrial site via active and passive data: the critical role of Love waves and the opportunities of multi-component group velocity analysis