Abstract:Nowadays, most wireless communications employ OFDM technology to reduce signal interference. Its sensitivity to timing faults, however, can cause a severe performance reduction. This study suggests a new approach to enhance communication systems' transmitting and receiving time. Although OFDM is a widely used modulation strategy in communication systems, it is vulnerable to timing faults, which can seriously affect performance. A frequency interference processing method is created that uses OFDM technology and goes through numerous steps, such as correcting CFO, adding a periodic prefix to prevent frequency distortion, calculating the time delay between transmission and reception, and spotting timing mistakes. It is clear that the lack of synchronization between the transmitter and channel interference has caused the Signal-to-Noise Ratio (SNR) to decline correspondingly. The initial approach had a piece of code that computed the transmission and reception times while recording their differences. As a result, it handles signal interference and frequency and temporal synchronization, two key aspects of OFDM. Timing precision varies from 0 to 1, and the time gap between transmission and reception is only a fraction of a second. When the SNR was available, timing errors and the lag between transmission and reception timing were seen, which suggests that there is a small probability of having too many locks or losing codes while utilizing OFDM. Simulation exercises show that the suggested method considerably enhances the system's Bit Error Rate (BER) performance in a variety of time offset conditions. The outcomes imply that the suggested strategy could be a workable remedy for OFDM systems with timing issues.

Sensing Accuracy Improvement of an OFDM W-band System

A W-Band Communication and Sensing Convergence System Enabled by Single OFDM Waveform

Fundamental Limits and Optimization of Multiband Delay Estimation in OFDM Systems

Optimal Tracking of Doubly-Selective Radio Channels for OFDM Based Modern Wireless Systems.

A Dual-Functional Sensing-Communication Waveform Design Based on OFDM

System Synchronization and Channel Estimation Analysis for IEEE 802.16e OFDMA Downlink System

An Innovative Environment Sensing Method Exploiting the Oversampled OFDM Cyclic Prefixes

Improved sampling clock error estimation algorithm in OFDM systems by using transform domain process

Cross-Domain Dual-Functional OFDM Waveform Design for Accurate Sensing/Positioning

Improved DFT-based channel estimation for OFDM systems over multipath channels

LoS Sensing-Based Channel Estimation in UAV-Assisted OFDM Systems

An improved detection algorithm based on frequency-domain PN-sequence for OFDM in wideband HF communication

A timing and frequency estimation algorithm for OFDM

Doppler Spread Estimation by Subspace Tracking for OFDM Systems

Improve initial ranging for uplink OFDMA systems by partial frequency sequence detection

Compressive Sensing Based Channel Estimation for OFDM Systems Under Long Delay Channels

A Power-Domain Non-Orthogonal Integrated Sensing and Communication Waveform Design Using OFDM

Performance analysis of joint range and velocity estimation in OFDM-IM-based RadCom system

Triangular FM-OFDM Waveform Design for Integrated Sensing and Communication

A New Approach to Improve Transmitting and Receiving Timing in Orthogonal Frequency Division Multiplexing (OFDM) Systems