Abstract:The nonlinear wavelength conversion can generate the laser wavelengths which are not directly available, thereby broadening the laser spectrum range. However, the existence of phase mismatch greatly limits the development and application of nonlinear optical technology. The wavelength conversion schemes in a manner analogous to population transfer in atomic rapid adiabatic passage, stimulated Raman adiabatic passage(STIRAP), and Stark chirped rapid adiabatic passage(SCRAP) provide feasible solutions for efficient and broadband wavelength conversion. SCRAP use the Stark shift caused by the Stark field to generate energy level crossings, thereby, the population in initial state can be efficiently converted to the target state. It does not require the two-photon resonance, can be applied to multi-photon transition. In this paper, by approximate analogy to the adiabatic population theory, a wavelength conversion model with the KTP crystals based on SCRAP is established, the influence of the coupling delay parameters, width parameters, pump intensity, temperature, and incident wavelength on the conversion process are systematically studied. The results show that signal laser energy can almost convert into output laser energy, while the intermediate laser energy is kept extremely low during the conversion process. The conversion process is sensitive to changes in coupling delay parameters, width parameters, and pump intensity. The farther away from the optimal coupling delay parameter, the lower the conversion efficiency. When the width parameter is fixed, as the width parameter increases, the conversion efficiency will first increase to the maximum, and then slowly decrease. At the same time, the greater the value of the width parameter , the greater the maximum conversion efficiency that can be achieved, and the greater the bandwidth that can achieve high-efficiency wavelength conversion. The conversion efficiency increases as the pump intensity increases. However, changes in temperature and incident wavelength have little effect on the conversion efficiency. The above research can provide a theoretical basis for the acquisition of ultraviolet to mid-infrared.

The Effect of Stress on the Frequency Conversion Efficiency of the Large Aperture Frequency Converter

Stress Analysis of KDP Single Crystals Caused by Thermal Expansion Mismatch during Traditional Growth

Effect of Stress-Dependent Thermal Conductivity on Thermo-Mechanical Coupling Behavior in GaN-Based Nanofilm under Pulse Heat Source

Optomechanical Analysis and Performance Optimization of Large-Aperture KDP Frequency Converter

Analysis of Second Harmonic Generation and Deformation of a KDP Crystal Based on Residual Stresses of the Supporting Frame

Residual Thermal Stress of a Mounted KDP Crystal after Cooling and Its Effects on Second Harmonic Generation of a High-Average-power Laser

Performance Improvement Method for Large Aperture Frequency Conversion Crystal

Effect of spatial refractive-index nonuniformities existed in a large-scale rapid growth KDP crystal on third-harmonic conversion

Mechanical sensitivity analysis and optimization of a large-aperture KDP frequency converter for higher SHG efficiency.

Stress-induced depolarization of Nd:glass in high-power laser amplifier

Temperature Nonuniformity Occurring During the Cooling Process of A Kdp Crystal and Its Effects on Second-Harmonic Generation

Simulation of thermo-effects in average-power Pockels cell and stress-induced birefringence compensation

Research on Point Supporting and Clamping Process of Large Aperture Frequency-Doubling Crystal

The wavelength conversion with KTP crystal based on stark-chirped rapid adiabatic passage

Adaptive Optics Mounting Method for Higher Second Harmonic Generation Efficiency of Large Aperture KDP Crystal

Analysis of Second Harmonic Generation of a KDP Crystal Based on Multi-Scale Topography Simulation

Study on the Effect of Second Harmonic Conversion on the Pulse Width

Determination of Stress Waves and Their Effect on the Damage Extension Induced by Surface Defects of KDP Crystals under Intense Laser Irradiation

Radiation Force of a High-Energy Laser and Its Effects on Second-Harmonic Generation.

Effect of local phase-mismatch on frequency doubling of high-power femtosecond laser pulses under quasi-phase-matched conditions

Optomechanical design and analysis of a self-adaptive mounting method for optimizing phase matching of large potassium dihydrogen phosphate converter