Abstract:In this study, research and development on the 3rd generation automobile steel, with targets of R-m x A no less than 30 GPa% at R-m, level of 1-1.5 GPa, was carried out to fabricate high strength and high ductility steel by two methodologies, one is the medium manganese steels fabricated by intercritical annealing through austenite reverted transformation (ART annealing) and another is the conventional carbon steels processed by quenching and partitioning(Q&P). The ultrafine grain sized austenite-ferrite duplex microstructure and the tempered martensite-fresh martensite-austenite multiphase microstructure were demonstrated based on the microstructure characterization in ART -annealed medium manganese steels and Q&P processed conventional carbon steels. In both heat treatment conditions, substantially enhanced ductility (30-40%) at ultrahigh tensile strength level (1-1.5 GPa) was obtained, which results in a significant improvement of the product of tensile strength to total elongation about 30-40 GPa%. Analysis on the work hardening behaviors and the relationship between microstructures and mechanical properties of the studied steels indicates that the greatly improved ductility results from the aid of the phase transformation induced plasticity (TRW effects) and the ultrahigh strength stems from the hard matrix, such as the ultrafine grained duplex structure in ART -annealed steels and the martensite matrix in Q&P processed carbon steels. It is interesting to find that a strong dependence of the product of tensile strength to total elongation on the fraction of retained austenite phase of steels produced by both ART-annealing and Q&P processing techniques. It was proved that both ART-annealing and Q&P processes can be applied to fabricate the third generation automobile sheet steels offering ultrahigh strength and high ductility.

Study on Salt Spray Delayed Cracking Performance of Ultra-high Strength Martensitic Steel

Study on Bending Beam Delayed Cracking of Ultra High-strength DP Steel for Automotive Use

Study on Deep Drawing Delayed Fracture Properties of 980MPa Steel Thin Sheets for Automotive

Delayed fracture property of 1180 MPa grade ultra high-strength steel sheet used for automotive

STUDY OF FAILURE CRITERION OF ADVANCED HIGH STRENGTH STEEL

Study on the controlling factors for the quenching crack sensitivity of ultra-strong automotive steel

Effects of Microstructure on Delayed Fracture of Ultra High-strength Steel

Effects of ultrasonic nanocrystal surface modification on the surface integrity, microstructure, and wear resistance of 300M martensitic ultra-high strength steel

Long Life High Strength Steels to Resist Fatigue Failure and Delayed Fracture

Delayed Fracture Behavior of Ultrafine Grained High Strength Steel

STRESS CORROSION CRACKING BEHAVIOR OF A NEW KIND OF ULTRAHIGH STRENGTH STEEL Cr12Ni4Mo2Co14 IN ACID ENVIRONMENT

The 3rd Generation Automobile Sheet Steels Presenting with Ultrahigh Strength and High Ductility

Hydrogen Embrittlement and Microstructure Characterization of 1500 MPa Martensitic Steel

Shear Fracture of Advanced High Strength Steels

Ultra-high Cycle Fatigue Fracture Mechanism of a Precipitation HardeningStainless Steel at Different Stress Ratios

Yielding Behavior and Strengthening Mechanisms of a High Strength Ultrafine‐Grained Cr–Mn–Ni–N Stainless Steel

Effect of Alloying Elements on Solidification Cracking Susceptibility of High Manganese Austenitic Steel

Importance of cold rolling and tempering on the microstructure evolution, precipitation behavior and mechanical responses of 9Cr3Co3W1Cu ferritic/martensitic steel

Experimental Study on Mechanical Properties of S30432 Steel Containing Martensitic Structure

Experimental study on surface integrity and fatigue life of an ultra-high strength steel by the composite strengthening process of pre-torsion and ultrasonic rolling

Integrated Computing Accelerates Design and Performance Control of New Maraging Steels