Abstract:Ultrasonic elliptical vibration-assisted cutting (UEVC) has been successfully applied in the precision and ultra-precision machining of hard and brittle materials due to its advantages of a low cutting force and minimal tool wear. This study developed a novel double-excitation ultrasonic elliptic vibration-assisted cutting (D-UEVC) device by coupling ultrasonic vibrations in orthogonal dual paths. A two-degree-of-freedom vibration system of the D-UEVC was modeled, form which the elliptical trajectory of the end under different phase angle φ values was derived. The initial dimensions of the D-UEVC device were obtained through theoretical calculations. Subsequently, with the aid of finite element analysis methods, structural dynamic analysis of the device was conducted to obtain the elliptical vibration trajectory under different phase differences of the excitation source. In order to verify the cutting trajectory and cutting performance of the D-UEVC device, a prototype of the device was developed, and a series of vibration performance tests as well as the Inconel 718 cutting experiment were conducted. The experimental results illustrated that the D-UEVC device can achieve the elliptical vibration trajectory at the tool tip with a resonant frequency of 36.5 KHz. The adjustable elliptical vibration trajectories covered a range of ±4 μm in the axial and radial directions. Compared with the surface roughness Ra = 0.36 μm under the conventional cutting, the surface roughness of Inconel 718 under D-UEVC was Ra = 0.215 μm. Thus, the surface quality can be significant improved by utilizing the D-UEVC device.

Design of an ultrasonic elliptical vibration device with two stationary points for ultra-precision cutting.

A Novel Ultrasonic Elliptical Vibration Cutting Device Based on a Sandwiched and Symmetrical Structure

Developmental and Experimental Study on a Double-Excitation Ultrasonic Elliptical Vibration-Assisted Cutting Device

Design and Implementation of a Novel Single-Driven Ultrasonic Elliptical Vibration Assisted Cutting Device

Design of ultrasonic elliptical vibration cutting system for tungsten heavy alloy

Design Optimization of Ultrasonic Vibration Cutting Tool to Generate Well-Decoupled Elliptical Trajectory

Experimental and simulation investigation of ultrasonic elliptical vibration cutting of tungsten alloys in ultra-precision machining

Experimental and analytical study of ultrasonic elliptical vibration cutting of micro-pyramid reflective mold based on guided wave transmission

Mechanically Enabled Two-Axis Ultrasonic-Assisted System for Ultra-Precision Machining

The Finite Element Analysis and Optimization of an Elliptical Vibration Assisted Cutting Device

Modulated ultrasonic elliptical vibration cutting for ductile-regime texturing of brittle materials with 2-D combined resonant and non-resonant vibrations

Development of a high-precision piezoelectric ultrasonic milling tool using longitudinal-bending hybrid transducer

Design of Ultrasonic Machining Device for Thin-Wall Cylinder of Air Compressor

Development of A Two-Dimensional Ultrasonic Vibration Assisted Machining Technology with Tool Vibration

Numerical analysis in ultrasonic elliptical vibration cutting (UEVC) combined with electrical discharge assistance (EDA) for Ti6Al4V

Analytical modelling and experimental study of surface roughness in ultrasonic elliptical vibration assisted ultra-precision cutting of Ti-6Al-4 V alloy

Ultrasonic Elliptical Vibration Texturing of the Rake Face of Carbide Cutting Tools for Adhesion Reduction

Design and Experimental Study of an Ultrasonic Generator for Precision Vibration Cutting

Effect of Vibration Parameters on Ultrasonically Elliptical Vibration Cutting

A novel quasi-intermittent vibration assisted swing cutting device: Design and experimental investigation

Ultrasonic vibrating system design and tool analysis