Abstract:A general two-dimensional (2D) theoretical approach capable of providing an explicit closed-form solution is developed for the calculation of elastic stresses in single-lap adhesive bonded joints, assuming linear distribution of a longitudinal normal stress in the joint thickness direction. By treating the adhesive layer in the same way as the adherends, the two-dimensional stress and strain distributions at any point, and the tensile force, shearing and bending moment at any cross section can be predicted accurately, in both the adhesive and adherends. This makes it possible for the subsequent failure analysis of the bonded joints to predict all the main modes such as adherend failure, cohesive failure and adhesive failure. The analysis is based on a two-dimensional elasticity theory that both includes the complete stress-strain and the complete strain-displacement relationships for the adhesive and adherends. Then, through the use of the displacement continuity conditions at the interfaces between the adhesive and adherends, four coupled, fifth-order ordinary differential equations with constant coefficients for the determination of the stresses are developed. The proposed method is capable of satisfying all the boundary stress conditions of the joint, including the stress-free surface condition at the ends of the bondline. The calibration of the new theoretical approach was verified by comparing it with the previously theoretical solutions, and the 2D geometrically nonlinear finite element models with the rotation and non-rotation boundary conditions. It is indicated that the present solution can provide a good prediction for the stress and strain distributions in the adhesive and adherends. A different approach is also established for determining bending moment factor of the short joints wherein the consideration of overall joint moment equilibrium is emphasized. It was shown that when the proposed bending moment factor is adopted instead of the original one, the classical solution by Goland and Reissner (1944) [4] might still remain applicable to the adherends and adhesive even with the parameter E3t1/(E1t3) 0.1.

Estimation Method of Interfacial Stress Distribution by Inverse Analysis of Deformed Shape Data.

Numerical simulation of influence factors of stress distribution of weld-bonded joint under peeling load

Analytical Solution for Externally Bonded Joints Considering Snap-Back

Interfacial stress analysis of a thin plate bonded to a rigid substrate and subjected to inclined loading

Acoustoelastic determination of local surface stresses in polymethylmethacrylate

A novel approach for the interfacial stress analysis of composite adhesively bonded joints

Identification of Time-Dependent Interfacial Mechanical Properties of Adhesive by Hybrid/inverse Method

Analytical solution for the interfacial stress and energy release rate at failure initiation of the three-point bending test (ISO 14679:1997)

Elastic Stress Analysis of Single-Lap Adhesive-Bonded Joints

A Two-Dimensional Approach of Single-Lap Adhesive Bonded Joints

A novel cylindrical punch method to characterize interfacial adhesion and residual stress of a thin polymer film

STRESS ANALYSIS OF CRACKED PLATE WITH ADHESIVELY BONDING

A TWO-DIMENSIONAL SOLUTION FOR UNSYMMETRIC SINGLE-LAP ADHESIVE BONDED JOINTS

Experimental approach for measuring the peeling strength of a sheet bonded on a curved adherend with pressure sensitive adhesive and predicting the peeling resistance by finite element analysis

A novel approach based on stress-impedance effect to assess the interfacial properties in fiber-reinforced composites

Effects of Residual Stresses on Interfacial Adhesion Measurement

Achieving Ultrastrong Adhesion of Soft Materials by Discretized Stress Dispersion

Decohesion of a rigid flat punch from an elastic layer of finite thickness

Identification of Contact Stress on Non-conforming Contact Interface Based on Local Displacement Measurement

Theory-Aided Full Field Strain Measurement Method for the Accurate Characterization of Elastic Contact Deformation

Interfacial stress analysis of plated beams under symmetric mechanical and thermal loading