Abstract:CO2 oxidative dehydrogenation of propane (CO2-ODHP), being not only favorable for olefin production but also beneficial for CO2 emission control, has recently attracted great attention. Here, a series of single metal (Cr) and bimetal (Zr, La, Fe) modified ZSM-5 zeolites were prepared via an impregnation method. It was found that the bimetal modified ZSM-5 possessed much higher C3H8 and CO2 conversion than that of monometallic modified Cr3%-ZSM-5 (Cr3%-Z5), especially for Cr3%Zr2%-ZSM-5 (Cr3%Zr2%-Z5), which displayed the highest activity (65.4%) and olefin yield (1.65 × 103 μmol·gcat−1 h−1). Various characterizations were performed, including XRD, N2 adsorption-desorption, H2-TPR, Raman, XPS, HAAD-STEM, and TEM. It was revealed that Zr not only favored an improvement in the redox ability of Cr, but also contributed to the surface dispersion of loaded Cr species, constituting two major reasons explaining the superior activity of Cr3%Zr2%-Z5. To further improve CO2-ODHP catalytic behavior, a series of Cr3%-ZSM-5@SBA-15-n composite zeolite catalysts with diverse (ZSM-5/SBA-15) mass ratios were prepared (Cr3%-ZS-n, n = 0.5, 2, 6, 16), which screened out an optimum mass ratio of six. Based on this, the Cr3%Zr2%-ZS-6 compound was further prepared, and it eventually achieved even higher CO2-ODHP activity (76.9%) and olefin yield (1.72 × 103 μmol·gcat−1 h−1). Finally, the CO2-ODHP reaction mechanism was further investigated using in situ FTIR, and it was found that the reaction followed the Mars–van Krevelen mechanism, wherein CO2 participated in the reaction through generation of polydentate carbonates. The Cr6+ constituted as the active site, which was reduced to Cr3+ after the dihydrogen reaction, and was then further oxidized into Cr6+ by CO2, forming polydentate carbonates, and thus cycling the reactive species Cr6+. Additionally, assisted by a Brönsted acid site (favoring breaking of the C-C bond), C2H4 and CH4 were produced.

Effective conversion of CO 2 into light olefins over a bifunctional catalyst consisting of La-modified ZnZrO x oxide and acidic zeolite

Bifunctional Catalysts Composed of Low Silicon‐content SAPO‐34 Nanosheets and in 2 O 3 /zro 2 with Improved Performance for CO 2 Hydrogenation

Carbon Dioxide Hydrogenation to Light Olefins over ZnO-Y2O3 and SAPO-34 Bifunctional Catalysts

Bifunctional catalyst consisting of In-modified GaZrOx ternary solid solution oxide and SAPO-34 for efficiently converting CO 2 into light olefins

Bifunctional Catalyst Ga2O3-mZrO2/SAPO-34 for CO2 Hydrogenation: Ga2O3-mZrO2 Improving Light Olefins

Tuning CO2 Hydrogenation to Light Olefin Selectivity via Cu/Zn/Zr Supported on Modified SAPO‐34

Conversion of syngas into light olefins over bifunctional ZnCeZrO/SAPO-34 catalysts: regulation of the surface oxygen vacancy concentration and its relation to the catalytic performance

Zn promoted GaZrOx ternary solid solution oxide combined with SAPO‐34 effectively converts CO2 to light olefins with low CO selectivity

ZrO2–ZnO–CeO2 integrated with nano-sized SAPO-34 zeolite for CO2 hydrogenation to light olefins

Hydrogenation of CO2 to Light Olefins over ZnZrOx/SSZ‐13

Role of Zr loading into In2O3 catalysts for the direct conversion of CO2/CO mixtures into light olefins

Highly Active Catalytic CO2 Hydrogenation to Lower Olefins via Spinel ZnGaOx Combined with SAPO-34

CO 2 hydrogenation to light olefins over Zn–Zr/support-SAPO-34: comparison of different supports

Highly effective conversion of CO2 into light olefins abundant in ethene

GamCrOx/H-SAPO-34(F), a highly efficient bifunctional catalyst for the direct conversion of CO2 into ethene and propene

Synthesis of hierarchical SAPO-34 to improve the catalytic performance of bifunctional catalysts for syngas-to-olefins reactions

Indium-Promoted ZnZrO x /nano-ZSM-5 for Efficient Conversion of CO 2 to Aromatics with High Selectivity

Selective conversion of syngas to light olefins

CO2 Oxidative Dehydrogenation of Propane to Olefin over Cr-M (M = Zr, La, Fe) Based Zeolite Catalyst

Role of Residual CO Molecules in OX–ZEO Relay Catalysis for Syngas Direct Conversion

Selective conversion of bio-oil to light olefins: Controlling catalytic cracking for maximum olefins