Abstract:To obtain fine and disordered precipitated phases and coordinate multiple strengthening mechanisms in face -centered cubic (FCC) high entropy alloys (HEAs), the Co30Cr30Fe17Ni17Mo6 HEA was prepared and annealed at various temperatures (800, 1000, and 1200 degrees C for 2 h, furnace cooling). The phase stability, microstructure evolution, and tensile properties were systematically investigated at room and low temperatures. The as-cast alloy is consisted of the FCC phase and primary sigma phase rich (Cr, Mo) element. The as-annealed alloy pre-cipitates a fine and disordered secondary sigma phase from the FCC matrix around the primary sigma phase. The average areal size of the secondary sigma phase gradually increases from 1.848 mu m2 to 2.307 mu m2 with the increase of as -annealed temperature. The highest Gibbs free energy of the FCC phase in thermodynamic and the sluggish diffusion kinetics of elements induce the fine and disordered secondary sigma phase precipitation. The as-annealed HEA has a high yield strength of 557 MPa at A800, increased by 21% compared with the as-cast alloy, and maintains applicable plasticity of 16.91% at 298 K. The as-annealed HEA at A1000 exhibits strength-ductility synergy at 203 K. The high yield strength is attributed to secondary sigma phase strengthening and sigma/FCC inter-face strengthening coordination. Dislocations accumulate and strongly interact at the sigma/FCC interfaces, which induces the formation of back stress in softer matrix phases. The back stress and dislocation cells provide the hardening of the FCC matrix at 298 K. The back stress, the net dislocations, and stack faults are activated in the FCC matrix phase to induce high strain hardening ability at 203 K. The FCC matrix with high strain hardening ability reduces stress concentration and delays crack initiation. The strain gradients are accumulated in the FCC matrix, secondary sigma phase, and primary sigma phase to realize strength-ductility synergy.

Effect of annealing temperatures on phase evolution and magnetic properties of Co35Cr5Fe10Ni30Ti5Al15 high entropy alloys

Fine tuning in-sync the mechanical and magnetic properties of FeCoNiAl0.25Mn0.25 high-entropy alloy through cold rolling and annealing treatment

Microstructural Evolution and Elevated-Temperature Strengthening Mechanism of Co-free FeCrMnNiV0.2Alx High-Entropy Alloys During Annealing

Effect of Annealing Temperatures on Recrystallization Behavior and Mechanical Properties of (Fe<sub>50</sub>Mn<sub>30</sub>Co<sub>10</sub>Cr<sub>10</sub>)<sub>97</s ub>Al<sub>3</sub> High-Entropy Alloy

Study on Precipitation in (cocrfemnni)90al6ti4 High Entropy Alloy

Achieving superior strength-ductility balance of Co–Cr–Fe–Ni high entropy alloy via annealing

Effects of Annealing on the Microstructure and Magnetic Property of the Mechanically Alloyed FeSiBAlNiM (m=co, Cu, Ag) Amorphous High Entropy Alloys

Evolution of phase stability and structural properties in CrFeNiTiV high-entropy alloy under high-temperature heat treatment conditions

Phase stability and strengthening behavior of as-annealed Co30Cr30Fe17Ni17Mo6 high entropy alloy at room and low temperatures

A Novel FeCoNiCr0.2Si0.2 High Entropy Alloy with an Excellent Balance of Mechanical and Soft Magnetic Properties

Effect of Annealing on Microstructure Evolution and Tensile Behavior of Hot-Rolled FeMnCoCrAl High-Entropy Alloy

Effect of Aluminum Addition on the Microstructure, Magnetic, and Mechanical Properties of FeCrCoNiMn High-Entropy Alloy

Effect of Heat Treatment Temperature on Microstructure and Properties of FeCoNiCuTi High–Entropy Alloy

Effect of annealing treatment on microstructural evolution and compressive behavior of Al0.5CrFeNi2.5Si0.25 high-entropy alloy

Microstructure and Magnetic Properties of the FeCoNi(CuAl)0.8Ga0.06 High-Entropy Alloy During the Phase Transition

Effects of Annealing Temperature on the Microstructure and Mechanical Properties of the As-Cast Dual-Phased CoCuFeMnNi High Entropy Alloys Fabricated by Vacuum Induction Melting Method

Microstructure evolution and mechanical behavior of a CoCrFeNiMn0.75Cu0.25 high-entropy alloy by thermo-mechanical treatment

Development of ultrafine grained cobalt-free AlCrFe2Ni2 high entropy alloy with superior mechanical properties by thermo-mechanical processing

Microstructure and mechanical properties of CoCrFeNiTa high entropy alloy prepared by mechanical alloying and spark plasma sintering

Effect of Annealing on Microstructure and Mechanical Properties for As-Sintered Co-free Al1·8CrCuFeNi2 High Entropy Alloy

Improving Mechanical Properties of Fe-Mn-Co-Cr High-Entropy Alloy via Annealing after Cold Rolling