Abstract:—These days, there are extensive signifies to the evolution of newfound control procedures like model predictive control. The finite-state predictive thrust control (FSPTC) for LIMs is still not deftly addressed by scholars and limited research was acted to exploit the FSPTC for LIM drive systems. Therefore, the current study proposes a novel finite-state predictive thrust control (NFSPTC) for linear induction motors (LIMs) with reduced numbers of voltage vectors (VVs) in the prediction phase. The NFSPTC utilizes the conventional direct thrust control (DTC) concept to reduce the required VVs from eight to only four which consist of two active vectors and two zero vectors. Decreasing the number of predicted VVs leads to a significant reduction in computational time. Moreover, the weighting factor is removed to reduce the effort in selecting the best weighting factor. Since the LIM drive system can be succeeded by developing a sensorless speed estimation, the linear speed is estimated depending on the model reference adaptive system (MRAS) before using actual sensors; thus, low cost can be attained. The suggested control approach is validated by simulation proofs based on a 3-kW arc machine. The gained findings clarified the effectiveness of the proposed four VVs control over the eight VVs procedure in dipping the thrust ripple. Besides, using the four VVs control under variable speed and fixed thrust load, the execution time was decreased by 50%. Furthermore, the proposed control procedures ensued in maintaining the primary flux linkage constant alongside succeeding a glowing-tracking speed profile throughout the tackled speed and thrust load variations."

Variable Sampling Frequency Model Predictive Torque Control for VSI-Fed IM Drives Without Current Sensors

Dynamic control set-model predictive control for field-oriented control of VSI-PMSM

Direct Torque Control for 2L-VSI PMSM Using Switching Instant Table.

Current Sampling Scheme for Finite-Control-Set Model Predictive Control of PMSM Drives with Two Shunt Resistors

Modulated Model Predictive Torque Control for Fault-Tolerant Inverter-Fed Induction Motor Drives With Single DC-Link Voltage Sensor

Fault-Tolerant Predictive Torque Control Design for Induction Motor Drives Based on Discrete Space Vector Modulation

Dual-Vector-Based Predictive Torque Control for Fault-Tolerant Inverter-Fed Induction Motor Drives With Adaptive Switching Instant

Variable Vector Model Predictive Control for Permanent Magnet Synchronous Motors Using a Single DC-Link Current Sensor

Dynamic-Linearization-Based Predictive Control of a Voltage-Source Inverter

An Improved Model Predictive Torque Control for PMSM Drives Based on Discrete Space Vector Modulation

Two-Vector-Based Model Predictive Torque Control Without Weighting Factors for Induction Motor Drives

Relegated Thrust Ripples for Linear Induction Motors Based-Four Voltage Vectors Finite-Set Predictive Control and Model Reference Adaptive System

Deadbeat Model-Predictive Torque Control With Discrete Space-Vector Modulation for PMSM Drives

Virtual vectors based predictive control of torque and flux of induction motor and speed sensorless drives

An Improved Finite Control Set Model Predictive Current Control for a Two-Phase Hybrid Stepper Motor Fed by a Three-Phase VSI

Common-Mode Voltage Reduction Method Based on Variable Sampling Frequency Finite Control Set-Model Predictive Control for PMSM Drive Systems

Triple-Voltage-Vector Model-Free Predictive Current Control for Four-Switch Three-Phase Inverter-Fed SPMSM Based on Discrete-Space-Vector Modulation

A Novel Stator Flux Oriented V/f Control Method in Sensorless Induction Motor Drives for Accuracy Improvement and Oscillation Suppression

Predictive Torque Control for PMSM Based on Weighting Factor Elimination and Fast Voltage Vector Selection

Direct Torque Control for Induction Motors Based on Minimum Voltage Vector Error

Variable-structure torque control of induction motors using space vector modulation