Abstract:Supported V2O5–WO3/TiO2 materials are employed as selective catalytic reduction (SCR) catalysts for NOx emission control from power plants. Fresh SCR catalysts usually receive exposure to harsh treatments in the industry to accelerate catalyst activation (calcination in air at 650 °C) and catalyst aging (hydrothermal aging at 650 °C) in a way that represents various points in the catalyst/product lifetime. The present study investigates the catalyst structural and chemical changes occurring during such harsh treatments. Three series of supported V2O5–WO3/TiO2 catalysts were prepared by incipient-wetness impregnation of aqueous ammonium metavanadate and metatungstate precursors. The catalysts were subsequently dried and calcined at 550 °C in O2, 650 °C in O2, and hydrothermal conditions (10% O2, 8% H2O, 7% CO2, and 75% N2) at 650 °C. The resulting catalysts were physically characterized by numerous techniques (in situ Raman; in situ IR; in situ high-field–high-spinning solid-state 51V MAS NMR; in situ electron paramagnetic resonance; X-ray diffraction; Brunauer, Emmett, and Teller surface area; and inductively coupled plasma) and chemically probed with adsorbed ammonia, SCR–TPSR, and the SCR reaction. The surface WOx sites on the TiO2 support behave as a textural promoter that stabilizes the TiO2 (anatase) phase from sintering and transforming to the undesirable crystalline TiO2 (rutile) phase that can lead to formation of a Ti1–xVxO2 (rutile) solid solution with reduced V4+ cations (∼7–15%). The surface VOx sites are mostly oligomerized as surface V5+Ox sites (∼50–85% oligomers) and the extent of oligomerization tends to increase with surface WOx coverage and calcination temperature. A major difference between the calcined and hydrothermally treated catalysts was the low concentration of surface NH3* species on Lewis acid sites for the hydrothermally treated catalysts, yet the SCR activity was almost comparable for both catalysts. This finding suggests that surface NH4+*, primarily associated with the surface VOx sites, are able to efficiently perform the SCR reaction. Given that multiple catalyst parameters were simultaneously varying during these treatments, it was difficult to correlate the SCR activity with any single catalyst parameter. A correlation, however, was found between the SCR TOF/activity and the sum of the surface NH3* and NH4+* species, which is dominated by the surface NH4+* species.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acscatal.1c02130.ICP of vanadium content of catalysts; crystallite sizes for supported VWTi catalysts treated at 650 °C; EPR determination of V4+; solid-state 51V MAS NMR spectra of dehydrated supported V2O5–WO3/TiO2 catalysts calcined at 650 °C; EPR spectra of non-vanadium species; in situ TP-IR spectra of surface ammonia species during SCR; correlation plots between steady-state SCR TOF values and structural properties of VWTi catalysts; and radar plots of catalytic activity and catalyst properties (PDF)This article has not yet been cited by other publications.

Enhanced Durability of Monolithic V2O5-WO3/TiO2 Catalysts Prepared by a Novel One-Pot Method for the Selective Catalytic Reduction of NOx with NH3

Ultra Hydrothermal Stability of CeO2-WO3/TiO2 for NH3-SCR of NO Compared to Traditional V2O5-WO3/TiO2 Catalyst

The Effects of Tungsten and Hydrothermal Aging in Promoting NH3-SCR Activity on V2O5/WO3-TiO2 Catalysts

Enhanced Hydrothermal Stability of a Manganese Metavanadate Catalyst Based on WO3–TiO2 for the Selective Catalytic Reduction of NOx with NH3

Liver abscess due to an unusual strain of Yersinia enterocolitica

Selective Catalytic Reduction of NOx with NH3 over Short-Range Ordered W-O-Fe Structures with High Thermal Stability

Selective Catalytic Removal of High Concentrations of NOx at Low Temperature

Structure–Activity Relationships of Hydrothermally Aged Titania-Supported Vanadium–Tungsten Oxide Catalysts for SCR of NO x Emissions with NH 3

V2O5-WO3/TiO2 Catalysts for Low Temperature NH3 SCR: Catalytic Activity and Characterization

V<sub>2</sub>O<sub>5</sub>-WO<sub>3</sub>/TiO<sub>2</sub> Catalysts for Low Temperature NH<sub>3</sub> SCR: Catalytic Activity and Characterization

Activity and Hydrothermal Stability of CeO_2–ZrO_2–WO_3 for the Selective Catalytic Reduction of NO_x with NH_3

Highly Efficient Mesoporous V2O5/WO3–TiO2 Catalyst for Selective Catalytic Reduction of NOx: Effect of the Valence of V on the Catalytic Performance

SO2 Promoted V2O5-MoO3/TiO2 Catalyst for NH3-SCR of NOx at Low Temperatures

Performance of V_2O_5-WO_3-MoO_3/TiO_2 Catalyst for Selective Catalytic Reduction of NO_x by NH_3

Effects of Silica Additive on the NH 3 -SCR Activity and Thermal Stability of a V 2 O 5 /WO 3 -Tio 2 Catalyst

Effect of Synthesis Methods on Activity of V2O5/CeO2/WO3-TiO2 Catalyst for Selective Catalytic Reduction of NOx with NH3

Performance of V2o5-Wo3-Moo3/Tio2 Catalyst for Selective Catalytic Reduction of Nox by Nh3

Tungsten Oxide Modified V2O5-Sb2O3/TiO2 Monolithic Catalyst: NH3-SCR Activity and Sulfur Resistance

Promotion Effect of Tungsten Oxide on SCR of NO with NH3 for the V2O5–WO3/Ti0.5Sn0.5O2 Catalyst: Experiments Combined with DFT Calculations

Enhancement of low-temperature NH3-SCR catalytic activity and H2O & SO2 resistance over commercial V2O5-MoO3/TiO2 catalyst by high shear-induced doping of expanded graphite

Alkali- and Sulfur-Resistant Tungsten-Based Catalysts for NOx Emissions Control.