Abstract:A series of in-plane structural studies of the traditional timber structures have been conducted since the 1999 Chi-Chi earthquake.Most of these studies were largely based on quasi-static tests, limited modelling studies are found on the dynamic behaviour of these structural types, in particular, the complex bracket systems.Owing to their complexity and the lack of proper seismic evaluation methods for this type of oriental timber structures, structural engineers often assume these timber connections bear no moment resistance, and thus, will tend to simplify them to two idealized extreme forms -fully rigid or fully-hinge/pin joint.Hence, the predicted outcomes often appeared to be unrealistic as they do not truly reflect the actual behaviour of the oriental timber structures.Under-estimation not only gives the public a misguided perception that traditional timber structures are weak and not durable, it also undermines its true seismic capability.From past experimental results, it is understood that oriental timber joints generally behaved like semi-rigid joints than hinges or pin, and the overall stiffness of the global structure is related to vertical loads, friction and partial embedment of wood fibers between contact surfaces.Close-form analytical models have been derived and the predictions fit well with the test results.For verification sake, the above models were subjected to two examinations.Firstly, the models' assumptions and calculated values were cross-validated with past dynamic tests of complex bracket sets with various vertical loads and structural system designs.Next, the calculated assumptions were applied to conventional numerical modelling software and the predictions were cross-referenced with test results.Preliminary results from the above examinations revealed that the predicted models and anticipated weak points of the global structures were generally in good agreement with the dynamic test results, hence the assumptions made generally work well in both static and dynamic tests.

Seismic Behaviour of Taiwanese Timber Complex Brackets Subjected to Out-of-plane Loading

Mechanical Model for Complex Brackets System of the Taiwanese Traditional Dieh-Dou Timber Structures

Dynamic characteristics of Taiwanese traditional Dieh-Dou timber structures

PRELIMINARY STRUCTURAL ANALYSIS STUDY OF THE CHINESE COMPLEX BRACKET SYSTEMS

Shaking Table Test of the Taiwanese Traditional Dieh-Dou Timber Frame

Analytical Study On Buckling Restrained Braced Composite Frames

Experimental Study On Seismic Behavior Of Innovative Multi-Cellular Cft-Walls With Tie-Bolts

Seismic Behaviors of High-Strength Bolted End-Plate Connected Composite Steel Beam and Square Concrete Filled Steel Tube Column Frames

Seismic Behavior of Buckling Restrained Braced Composite Frames

Structural Behavior of Traditional Dieh-Dou Timber Main Frame

Experimental and numerical analysis on seismic behavior of corner Dou-Gong bracket in ancient timber buildings

Seismic Performance Evaluation for a Traditional Chinese Timber-frame Structure

Dynamic performance of bracket complexes used in traditional timber structures in Japan

Seismic performance of Chinese traditional timber frames

Seismic Performance Evaluation on Composite Frame Structures with T-shaped Multi-Cellular CFST Columns

An experimental and numerical study on the coupling effect of CLT wall-to-floor angle bracket connections

Hysteresis behavior of traditional timber structures by full-scale tests

Cyclic Behavior of Gabled Frames with Web-Tapered Columns and Rafters

Damage-control design and hybrid tests of a full-scale two-story buckling-restrained braced steel moment frame with sliding gusset connections

An experimental and simulated investigation into the seismic performance of Chuan-dou timber structures with infilled walls

Analysis on the mechanical performance of Dougong bracket sets under eccentric vertical load