Abstract:The filling process in injection molding involves polymer melt and air with large density/viscosity ratios and the transient free surface. It is treated as a challenging viscoelastic-Newtonian two-phase flow problem especially on irregular domains. In this paper, the complex filling process for the irregular cavity is simulated using a combined finite element/discontinuous Galerkin/level set method with application to the socket with five inserts, which is rarely investigated. The rheological behaviour of the viscoelastic fluid is predicted according to the eXtended Pom-Pom (XPP) constitutive model. The level set method proposed from prior literature is utilized to capture the moving interface because of its simplicity and efficiency. The hybrid continuous and discontinuous Galerkin method is utilized to solve the viscoelastic incompressible Navier-Stokes equations. The second order Runge Kutta discontinuous Galerkin (RKDG) method is employed to deal with the XPP constitutive equation and the level set equation due to their hyperbolic natures. This combined algorithm is convenient to cope with the irregular cavity and avoid any stabilization terms. We first investigate the filling process of the rectangular cavity without and with a diamond insert and compare with other numerical and experimental results to illustrate the validity of the coupled method. Moreover, the cavity of the socket with five inserts is considered an application case. We analyze the influences of the inlet velocity and elasticity on physical quantities such as stresses, stretch, etc. The simulation results could provide some numerical predictions for the polymer industry.

An On-Line Measurement Scheme Of Melt-Front-Area During Injection Filling Via A Soft-Sensor Implementation

A Soft-Sensor Development for Melt-Flow-Length Measurement During Injection Mold Filling

Numerical simulation of filling flow of polymer melt in injection molding

Modeling of Melt-flow-length During Injection Filling Stage Based on Dynamic Neural Network Soft-sensor

Profiling of Injection Velocity for Uniform Mold Filling

Measurement and Analysis of Cavity Pressure and Melt Filling Capacity During Injection Molding

Development of A Transducer for In-Line and Through Cycle Monitoring of Key Process and Quality Variables in Injection Molding

New Approach to Develop a 3D Non-Isothermal Computational Framework for Injection Molding Process Based on Level Set Method

Numerical Simulation of Melt Filling and Gas Penetration in Gas Assisted Injection Molding

Research on A Numerical Schemes for Capturing Free Front During Injection Molding

Numerical Simulation of Polymer Filling Process by a Combined Finite Element/discontinuous Galerkin/level Set Method

Visualization and Monitoring of the Injection Molding Process Using Ultrasonic Phased Array

A Nondestructive Online Method for Monitoring the Injection Molding Process by Collecting and Analyzing Machine Running Data

Simulation of Polymer Molding Filling Process with an Adaptive Weld Line Capturing Algorithm

Numerical Simulation and Experimental Verification of the Filling Stage in Injection Molding

Numerical Simulation of Gas-Assisted Injection Molding Process for A Door Handle

In situ flow state characterization of molten resin at the inner mold in injection molding

Sensor placement study for online flow monitoring in liquid composite molding

Optimization of Parameters in Sequential Injecting Molding Process for Family Mold Using Response Surface Methodology

A Numerical Simulation of the Filling Stage in Injection Molding Based on a Surface Model

In-situ ultrasonic measurement of molten polymers during injection molding