Abstract:Heat transfer between binary particles in an internally heated downer pyrolyzer was carefully studied because it is an important element for the reactor design, but a consensus on the heat transfer process has not been achieved. Compared with the experimental, numerical simulation can provide more details for understanding the heat transfer process. In this work, the widely used multifluid model (MFM) was adopted with considering the multiscale heat convection, conduction, and radiation behaviors inside the downer pyrolyzer. To clearly recognize the exact route of how heat transfers from high-temperature char to low-temperature coal, herein, the rate of each heat transfer way was calculated and counted separately. It is found that the heat radiation and conduction directly transferred from char to coal are all relatively small, and the gas–coal convection is the main factor in the coal heating process. However, the heat carried by the gas into the pyrolyzer only accounts for less than 0.1% of the heat received by the coal, implying that the gas phase is only the heat source by direct contact while the char is the indirect but main heat source. This was confirmed by the thermal balance analysis. Therefore, a conclusion of two-stage heat convection processes was proposed, in which the heat first transfers from char to gas, then from gas to coal, and these two stages belong to heat convection. Hence, the gas phase plays an intermediate medium role in the heat transfer process. Furthermore, the final temperature of the coal increases with the decrease in heat carrier diameter but is not sensitive to the gas velocity. This work is expected to provide guidance for the optimization of an efficient downer-type pyrolyzer.

Effects Of Binary Component On Particle Velocity And Coking Behaviours In Downers

Effect of Injecting Inert Particles on Coking Prohibition and Particle Velocity Uniformization in Downer Reactors

CFD-DEM Simulation of Flow and Mixing Behavior in Downers with Different Entrance Structures

CFD-DEM Study on the Synergistic Effect of Coke Consumption and Particle Dynamics in the Blast Furnace Raceway

Effect of microwave modification on pulverized coal combustion properties

Kinetic Study on Co-Combustion of Pulverized Anthracite and Bituminite for Blast Furnace Injection

Intensification of hydrodynamics and heat transfer characteristics of coal-char-gas flow in a high solids-flux downer with swirling blade nozzle

Theoretically Studies of the Coal Particle Cluster Combustion Behavior in a Circulating Fluidized Bed

Pulverized Coal Combustion in Boundary Layer Turbulence Using Direct Numerical Simulation

Simulation of Heat Transfer in a Downer-Type Pyrolyzer with Binary Particles by Considering Carrying Gas Role in the Coal Heating Process

Investigating Particle and Volatile Evolution During Pulverized Coal Combustion Using High-Speed Digital In-Line Holography

Particles attrition of binary mixtures in the coal-fueled chemical looping system based on fluidized bed

Effect of Back Pressure on Gas-Solid Distribution Characteristics of Cyclone Distributor Applied in Powdered Coal-Fired Circulating Fluidized Bed Combustion System

Particle behaviors in a pulverized coal-fired sudden-expansion combustor with coaxial jets

Numerical study of a chemical looping combustion system: Effects of fuel type and particle size distributions on the operating performance

Kinetic Simulation Of Fine Particulate Matter Evolution And Deposition In A 25 Kw Pulverized Coal Combustor

Analysis of particle heating and devolatilization during rapid coal pyrolysis in a thermal plasma reactor

Effect of co-firing straw with two coals on the ash deposition behavior in a down-fired pulverized coal combustor

Particle-scale study of coal-direct chemical looping combustion (CLC)

Investigation of Mechanisms in Plasma-Assisted Ignition of Dispersed Coal Particle Streams

Influences of Secondary Gas Injection Pattern on Fluidized Bed Combustion Process: A CFD-DEM Study